1973 Volkswagen Beetle

Front registration plate font not substantially similar to the prescribed font (6.3.4d)

Nearside Rear Subframe mounting prescribed area is excessively corroded As marked (2.4.A.3)

Offside Front Steering component mounting prescribed area is excessively corroded Box Mounting area as marked (2.2.C.1h)

Service brake: efficiency below requirements (3.7.B.7)

Both rear tyres perished

Nearside Rear Outer C.V Boot Split

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Rear Outer C.V Boot Split

Steering system has slight free play detected at steering wheel Play in steering box (2.2.A.1a)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Nearside Rear Rear wheel bearing has slight play (2.6.2)

Nearside Rear Vehicle structure has slight corrosion (6.1.B.2)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Front Steering pivot point has slight play (2.2.B.1g)

Offside Rear Rear wheel bearing has slight play (2.6.2)

Offside Rear Vehicle structure has slight corrosion (6.1.B.2)

fuel lines perished

Front chassis cross member corroded

Nearside rear inner c.v gaitor split

Nearside rear outer drive shaft gaitor split

Offside rear inner c.v gaitor split

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Front Shock absorber has a serious fluid leak (2.7.3)

Offside Front Shock absorber has a serious fluid leak (2.7.3)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

offside front sill corroded and holed but not within 30cm of any mountings

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Headlamp aim too low (1.8)

Offside Front Fuel hose leaking (7.2.3)

Offside Headlamp aim too low (1.8)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

offside front sill corroded and holed but not within 30cm of any mountings

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Centre Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Stop lamp not working (1.2.1b)

Offside rear brake binding (3.7.B.1)

Front Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Front registration plate character(s) not correctly formed (6.3.4b)

Headlamp aim not tested (1.8.A.1c)

Horn not loud enough to be heard by another road user (1.6.2b)

Nearside Front Shock absorber has a serious fluid leak (2.7.3)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Stop lamp not working (1.2.1b)

Offside Front Brake pad(s) locking device missing (3.5.1l)

Offside Front Shock absorber has a serious fluid leak (2.7.3)

Offside Front Upper Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Trailing arm attachment bracket/mounting corroded and its strength is seriously reduced (2.4.G.1)

Offside Stop lamp not working (1.2.1b)

Rear Registration plate lamp not working (1.1.C.1d)

Rear Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

nearside rear above suspension corrosion visible but appears to be ok at time of test

sreering damper noisey and suspect not damping

Brake hydraulic reservoir fluid level below minimum level (3.6.G.1b)

Direction indicators flashing more than 120 times a minute (1.4.A.2g)

Nearside Front Steering component mounting prescribed area is excessively corroded (2.2.C.1h)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Headlamp aim too high (1.8)

Nearside Rear wheel cylinder leaking (3.6.A.1)

Nearside rear brake recording little or no effort (3.7.B.5a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Steering component mounting prescribed area is excessively corroded (2.2.C.1h)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.C.1b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Parking brake is not capable of being maintained in operation by direct mechanical action only (3.1.2)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Front Headlamp not working on main beam (1.7.5a)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Front Headlamp not working on main beam (1.7.5a)

Offside Front brake disc excessively pitted (3.5.1h)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)