2003 MG Zt-t

Front Inner Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

General underside corrosion

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Side repeater incorrect colour (4.4.3 (a))

General underside corrosion

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Suspension arm corroded but not seriously weakened all rear (5.3.3 (b) (i))

Suspension component mounting repair covered in underseal nearside sill (5.3.6 (a) (i))

Suspension component mounting repair covered in underseal offside sill (5.3.6 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Headlamp insecure (4.1.1 (c))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Anti-roll bar linkage insecurely attached (5.3.3 (a) (i))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear tyre run on flat

Suspension arm corroded but not seriously weakened all rear (5.3.3 (b) (i))

Suspension component mounting repair covered in underseal nearside sill (5.3.6 (a) (i))

Suspension component mounting repair covered in underseal offside sill (5.3.6 (a) (i))

Central Rear Stop lamp(s) with a multiple light source up to 1/2 not functioning High level (4.3.1 (a) (i))

Offside Front Inner Steering linkage ball joint has slight play (2.1.3 (b) (i))

Central Rear Seat belt buckle not functioning as intended (7.1.2 (d))

Driver's seat fore and aft adjustment mechanism not functioning as intended. (6.2.5 (b) (i))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Central Rear Stop lamp(s) with a multiple light source up to 1/2 not functioning High level (4.3.1 (a) (i))

Offside Front Inner Steering linkage ball joint has slight play (2.1.3 (b) (i))

Headlamp aim too low both head light aims , no pattern and too low n/s and o/s (4.1.2 (a))

Headlamp not working on main beam does not operate with switch (4.1.1 (a) (ii))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Undertray likely to become detached no undertray both side flitchs insecure because they bolt on to this under tray (6.2.1 (a) (ii)) DANGEROUS

Fuel tank slightly loose condition of tank straps corroced (6.1.3 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Brake pipe excessively corroded both dual front to rear main brake pipes (3.6.B.2c)

Brake pipe excessively corroded n/s and o/s rear brake pipes and cross -over by fuel tank (3.6.B.2c)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Offside Brake pipe slightly corroded (3.6.B.2c)

osr /nsf/osf tyres close to limits

osr wing dented

rear exhaust carroded

wiper split

Brake pipe slightly corroded (3.6.B.2c)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Brake pipe slightly corroded (3.6.B.2c)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Brake pipe slightly corroded (3.6.B.2c)

Child seat fitted not allowing full inspection of adult belt

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Parking brake lever has little reserve travel (3.1.6b)

coolant leak

nearside rear sill skimmed in fillter

Offside Rear rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Brake pipe slightly corroded (3.6.B.2c)

Child seat fitted not allowing full inspection of adult belt

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Parking brake lever has little reserve travel (3.1.6b)

coolant leak

nearside rear sill skimmed in fillter

Offside Front Headlamp aim too low (1.8)

Offside Rear Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

rear exhaust heat shied inscure

Offside Rear Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

rear exhaust heat shied inscure

Brake pedal creeps down while the pedal is held under pressure (3.3.B.1a)

Front Body has a sharp edge caused by damage (6.1.C.1)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Headlamp aim not tested (1.8.A.1c)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Front Headlamp aim too low (1.8)

Offside Registration plate lamp not working (1.1.C.1d)

front and rear brake disc scored and pitted

Offside Stop lamp not working (1.2.1b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Stop lamp not working (1.2.1b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)