2008 Ford Ka

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced floor (7.1.1 (a) (i))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Brake hydraulic reservoir fluid level below minimum level (1.1.10 (d) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Inner Subframe mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Inner Subframe mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Integral body structure is deformed but structural rigidity is not significantly reduced Front cross member behind front bumper (6.1.1 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive Chassis at subframe mounting (5.3.6 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge 2mm (5.2.3 (e))

Nearside Windscreen wiper blade defective (3.4 (b) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive Chassis at subframe mounting (5.3.6 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge 2mm (5.2.3 (e))

Offside Headlamp aim too low (4.1.2 (a))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

underside of vehicle corroded in areas

Offside Front headlamp slight water ingress

corrosion around fuel filler

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Registration plate lamp not working (1.1.C.1d)

Offside Front headlamp slight water ingress

corrosion around fuel filler

Corrosion forming on offside and nearside rear inner sill area

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

corrosion forming on offside and nearside rear inner sill areas

Nearside Side repeater incorrect colour (1.4.A.2f)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Inner Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear position lamp(s) not working (1.1.A.3b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

corrosion forming on offside and nearside rear inner sill areas

Nearside Headlamp not working on dipped beam (1.7.5a)

drivers seat padding worn

drivers seat padding worn

small cuts o/s/f tyre outer wall

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Registration plate lamp not working (1.1.C.1d)

small cuts o/s/f tyre outer wall

Nearside Rear position lamp(s) not working (1.1.A.3b)

Offside Rear Direction indicator not working (1.4.A.2c)

Offside Stop lamp not working (1.2.1b)

Brakes imbalanced across an axle (3.7.B.5b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)