1979 Austin Morris Mini 1275 GT

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust emits blue smoke during acceleration (7.3.A.2c)

Nearside Rear wheel bearing has slight play (2.6.2)

Exhaust emits blue smoke during acceleration (7.3.A.2c)

Nearside Rear rear brake recording little or no effort (3.7.B.5a)

Offside Rear rear brake recording little or no effort (3.7.B.5a)

Service brake: efficiency below requirements (3.7.B.7)

Exhaust emits blue smoke during acceleration (7.3.A.2c)

Exhaust emits blue smoke during acceleration (7.3.A.2c)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Steering column top bearing slightly worn (2.1.2c)

Front Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tie bar/rod has slight play in a pin/bush (2.4.G.2)

o/s/f tyre perished outer wall

NOTE H. C. level checked at fast idle

NOTE extensive modifications carried out to vehicle

NOTE extensive welding & undersealing carried out to vehicle

NOTE non standard seat belts fitted

NOTE only front seats fitted at time of test

braided brake hoses fitted

Exhaust emissions hydrocarbon content excessive (7.3.B.1b)

Nearside Front Front wheel bearing has excessive play (2.5.A.3c)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Nearside Front Upper Suspension arm has excessive play in a pin/bush (2.4.G.2)

Nearside Hazard warning lamps not flashing in phase, with ignition off (1.4.B.1f)

Nearside Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Offside Front Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Fuel system component insecure (7.2.1) DANGEROUS

Exhaust emits blue smoke during acceleration (7.3.A.2c)

NOTE braided brake hoses fitted

NOTE extensive modifications have been made to vehicle

NOTE extensive welding repairs & undersealing have been carried out to vehicle

NOTE non standard seat belts fitted

NOTE only front seats fitted at time of test

brake pipes under bonnet slightly insecure, add more retaining clips

check condition of fuel hoses to fuel pump

fuel cap seal perishing

wiper blades perishing

Exhaust emissions hydrocarbon content excessive (7.3.B.1b)

Front Brake pipe inadequately clipped (3.6.B.1)

Hazard warning tell tale not working correctly (1.4.B.1e)

Nearside Front Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Nearside Steering rack gaiter split (2.2.D.2d)

Offside Front Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Offside Front Vehicle structure has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Hazard warning lamps not flashing in phase, with ignition off (1.4.B.1f)

Rear Brake pipe inadequately clipped (3.6.B.1)

Bonnet retaining device ineffective (8.4.2)

Exhaust emissions hydrocarbon content excessive (7.3.B.1b)

Horn not working (1.6.2a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

rust nsr floor