2003 Toyota Yaris

exhaust system corroded and slight leak at joint to the rear silencer

front headlamps discolouring but not affecting beam image

inner sills corroded

nearside front tyre worn to outer tread

nearside rear tyre distorting heavily to inner tread on 1.6mm legal at time of test only..only just acceptable

offside front tyre worn heavily to inner and outer edges of tread

offside rear outer sill corroded

rear coil springs corroded

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre worn close to the legal limit on 3mm wearing to inner edge (4.1.E.1)

Nearside Headlamp deteriorated but light output not reduced (1.7.5a)

Nearside Rear Tyre worn close to the legal limit on 2mm wearing to inner and distorting (4.1.E.1)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit on 3mm wearing to inner edge (4.1.E.1)

Offside Headlamp deteriorated but light output not reduced (1.7.5a)

Offside Rear coil spring corroded (2.4.C.1b)

nearside and offside inner rear sill corrosion

corrosion to rear chassis box sections

front suspension bushes perishing

nearside rear tyre distorting to tread

Damage to body work.

Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Front exhaust not fully supported and will rquire attention...just acceptable.

Headlamp aim too low (1.8)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Lower Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Both head-light lens faded and showing a poor pattern.

Damage to body work.

Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Front exhaust not fully supported and will rquire attention...just acceptable.

Both head-light lens faded giving poor pattern.

Exhaust system centre and rear corroded and deteriorated.

Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Damage to o/s/f door and rear panel.

Exhaust deteriorated.

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

High level brake light not working.

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

n/s wiper bladesplit on lower end.

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Horn not working (1.6.2a)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Rear Tyre worn close to the legal limit (4.1.E.1)

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)