2003 BMW Z4

Brake pipe corroded, covered in grease or other material Both sides front to rear, Rear section (1.1.11 (c))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Brake pipe corroded, covered in grease or other material Both sides front to rear, rear sections (1.1.11 (c))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Both sides handbrake needs attention only just met requirements

Brake pipe corroded, covered in grease or other material Both front to rear, Rear sections (1.1.11 (c))

Front Inner Brake disc worn, but not excessively Both sides (1.1.14 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material To rears rear sections (1.1.11 (c))

Nearside Rear Handbrake would benefit from further attention

Brake pipe corroded, covered in grease or other material Both side front to rear, Rear sections (1.1.11 (c))

Rear Brake pipe corroded, covered in grease or other material Both sides (1.1.11 (c))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1) DANGEROUS

Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Rear Brake pad(s) wearing thin (3.5.1g)

both nearside tyres on limit

Nearside Front Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Front Suspension arm has excessive play in a pin/bearing (2.4.G.2)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

engine undertrays fitted

nearside rear tyre wearing slightly on inner edge

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Road wheel bead rim badly distorted (4.2.A.1a)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Tyre worn close to the legal limit (4.1.E.1)