2014 Yamaha Wr

Front Tyre worn close to the legal limit (5.2.3 (e))

Drive chain horseshoe locking device incorrectly fitted (6.1.7 (j) (i))

Front Tyre worn close to the legal limit (5.2.3 (e))

Clutch lever has slight movement

Exhaust noisy (8.1.1 (a))

Front brake lever has slight movement

Drive chain excessively tight (6.1.7 (k) (i))

Fuel cap ineffective Sealing washer missing (6.1.3 (b) (i))

Horn not working (7.7 (a))

Rear Position lamp not working (4.2.1 (a))

Rear reflector missing (4.8.2 (a) (ii))

Registration plate does not conform to the specified requirements (0.1 (d))

Stop lamp does not illuminate by the operation of both brake controls (4.3.2 (a) (iii)) DANGEROUS

Clutch lever has slight movement

Exhaust noisy (8.1.1 (a))

Front brake lever has slight movement

Exhaust noisy (8.1.1 (a))

Rear Lower Suspension arm pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

clutch lever has up and down movement

Nearside Rear Direction indicator with a multiple light source more than 1/2 not functioning (4.4.1 (a) (ii))

Offside Front Stop lamp not working (4.3.1 (a) (ii))

Rear Lower Shock absorber has an excessively worn bush (5.3.2 (c))

Rear reflector missing (4.8.2 (a) (ii))

Registration plate does not conform to the specified requirements (0.1 (d))

Exhaust noisy (8.1.1 (a))

Rear Lower Suspension arm pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

clutch lever has up and down movement

Rear Brake pad(s) close to minimum limit (1.1.13 (a))

Rear Brake pad(s) close to minimum limit (1.1.13 (a))

Rear Registration plate does not conform to the specified requirements (0.1 (d))

Front Drive chain sprocket so worn it is likely to fail (6.1.7 (c) (ii))

Rear Drive chain so worn it is likely to fail (6.1.7 (c) (ii))

Rear Drive chain sprocket so worn it is likely to fail (6.1.7 (c) (ii))

Front Tyre worn close to the legal limit (5.2.3 (e))

Direction indicators flashing more than 120 times per minute (1.5.1c)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Registration plate not fixed vertically, or as close to vertical as is reasonably practical (6.3.2b)