2005 Fiat Stilo

Front Headlamp has a product on the lens but not seriously reducing light output Both (4.1.4 (b))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Non standard fuel cap fitted

Rear Axle beam bushs worn and knocking

Rear Engine mounting damaged but not to excess (6.1.8 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Headlamp has a product on the lens but not seriously reducing light output Both (4.1.4 (b))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Non standard fuel cap fitted

Rear Axle beam bushs worn and knocking

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Non standard fuel cap fitted

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn Axle beam rubber bushs worn /knocking (5.1.2 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Both rear axle beam rubber bushs spit causing heavy knock

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Incorrect fuel cap fitted

Nearside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust mounting defective All rubber hangers (6.1.2 (a))

Incorrect fuel cap fitted

Nearside Front Nail in tyre ()

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Exhaust has a minor leak of exhaust gases Box tail pipe (6.1.2 (a))

Rear axle beam bushs worn

Subframe mounting prescribed area damaged but not considered excessive Front and rear sub frames and all realated components (5.3.6 (a) (i))

Nearside Rear Direction indicator incorrect colour (4.4.3 (a))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Exhaust mounting defective All rubber hangers (6.1.2 (a))

Incorrect fuel cap fitted

Nearside Front Nail in tyre ()

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Exhaust has a minor leak of exhaust gases Box tail pipe (6.1.2 (a))

Rear axle beam bushs worn

Subframe mounting prescribed area damaged but not considered excessive Front and rear sub frames and all realated components (5.3.6 (a) (i))

Brake hydraulic reservoir close to minimum mark (1.1.10 (d) (i))

Brake pad(s) wearing thin all (1.1.13 (a) (ii))

coolant low

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Fuel cap/sealing device missing (6.1.3 (b) (i))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Brake hydraulic reservoir close to minimum mark (1.1.10 (d) (i))

Brake pad(s) wearing thin all (1.1.13 (a) (ii))

coolant low

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Gearbox/engine mount feels weak on load

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear exhaust box corroded

Surface corrosion front subframe rear axle beam

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Anti-roll bar linkage insecurely attached (5.3.3 (a) (i))

Offside Headlamp aim too high (4.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Temp repair to exhaust blow

Front Exhaust has a major leak of exhaust gases pipe joint (7.1.2)

Nearside Rear Direction indicator incorrect colour (1.4.A.2f)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Headlamp aim too high (1.8)

Offside Rear Direction indicator incorrect colour (1.4.A.2f)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords inner side wall (4.1.D.1a)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

OFFSIDE REAR TYRE INNER WALL PERISHING/SPLITTING, CORD NOT EXPOSED YET

REAR SUBFRAME BUSHES DETERIORATING

slight movement offside rear axle bush.

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Front coil spring broken (2.4.C.1a)

front tyres on wear limit and worn out on inner edge, advise replacement.

rear brake pads on wear limit.

slight movement offside rear axle bush.

Rear Brake pad(s) wearing thin (3.5.1g)

both front tyres worn on inner edge on legal limit

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Windscreen wiper not operating automatically when switched on (8.2.1b)

Rear Brake pad(s) wearing thin (3.5.1g)

both front tyres worn on inner edge on legal limit

front tyres wearing on inner edge.

rear brake pads getting thin.

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

front tyres wearing on inner edge.

rear brake pads getting thin.

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

nearside front tyre getting close to limit and inner wall splitting.