2010 Mercedes-benz C

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Front Headlamp aim unable to be tested (4.1.2 (b))

Nearside Front Position lamp not working dip beam (4.2.1 (a) (ii))

Nearside Front Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Nearside Rear Brake performance unable to be tested rear suspension lower arm broken away from rear subframe (1.2.1 (g))

Nearside Rear Outer Position lamp not working side light (4.2.1 (a) (ii))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Subframe mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected lower broken away (5.3.6 (a) (ii)) DANGEROUS

Brake disc worn, pitted or scored, but not seriously weakened both fronts (1.1.14 (a) (ii))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Stop lamp(s) with a multiple light source up to 1/2 not functioning (4.3.1 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement top mounts (5.3.4 (a) (i))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Front Anti-roll bar ball joint dust cover severely deteriorated both sides (5.3.4 (b) (i))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement both sides front (5.3.4 (a) (i))

Front Wheel bearing has slight play both sides (5.1.3 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Front Brake pad(s) wearing thin BOTH (1.1.13 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Brake pipe excessively corroded to flexi (1.1.11 (c))

Offside Rear Brake pipe excessively corroded to flexi (1.1.11 (c))

Front Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Rear Brake pipe corroded, covered in grease or other material both sides front to rear and rear (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Brake pipe corroded, covered in grease or other material nsf /osf (1.1.11 (c))

Rear Brake pipe corroded, covered in grease or other material osr /nsr (1.1.11 (c))

prop-shaft rear coupling perishing and splitting

slight corrosion to rear sub frame

coolant leak from waterpump

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

front tyres going bald on very edges.