2015 Mazda 6

suspension components corroded

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

suspension components corroded

Nearside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill / Axle mounting (5.3.6 (a) (i))

Nearside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Parking brake only just met the minimum efficiency requirement

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Headlamp aim too low and too far to the right. Will not adjust (4.1.2 (a))

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure 205/55 R16 (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Parking brake only just met the minimum efficiency requirement

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

General corrosion to all underside

Nearside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Parking brake only just met the minimum efficiency requirement

Underside of vehicle extensively corroded but not affecting structural integrity

Parking brake only just met the minimum efficiency requirement

Central Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Headlamp levelling device inoperative (4.1.5 (a))

Offside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Headlamp aim too high (4.1.2 (a))

Parking brake only just met the minimum efficiency requirement

Rear subframe area very rusty and rust hole into boot

general under body corrosion

Under side corroded

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

underside has some corrosion (rear)

Nearside Rear Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Rear Tyre has ply or cords exposed side wall (4.1.D.1b)