2002 Fiat Punto

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pipe corroded, covered in grease or other material coating swollen (1.1.11 (c))

Nearside Seat belt anchorage prescribed area is corroded but not considered excessive floor pan to sill areas (7.1.1 (a) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced jacking point (6.1.1 (c) (i))

Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Rear Shock absorbers light misting of oil or has limited damping effect both (5.3.2 (b))

Rear axle assembly corroded

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a major leak of exhaust gases front and centre (6.1.2 (a))

Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced floor pan holed by sub-frame mount and jacking point (6.1.1 (c) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced sill to floor pan holed (7.1.1 (a) (i))

Rear Exhaust system insecure (6.1.2 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pipe corroded, covered in grease or other material coating swollen (1.1.11 (c))

Nearside Seat belt anchorage prescribed area is corroded but not considered excessive floor pan to sill areas (7.1.1 (a) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced jacking point (6.1.1 (c) (i))

Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Rear Shock absorbers light misting of oil or has limited damping effect both (5.3.2 (b))

Rear axle assembly corroded

Brake pipe corroded, covered in grease or other material plastic coating swollen on both rear and off side front (1.1.11 (c))

Exhaust has a minor leak of exhaust gases front and centre sections (6.1.2 (a))

Rear Shock absorbers light misting of oil or has limited damping effect both (5.3.2 (b))

Vehicle structure is corroded but structural rigidity is not significantly reduced both sill areas (6.1.1 (c) (i))

Clutch hydraulic pipe badly coroded

Front both headlamp lenses slightly deteriorated. Image ok

Rear Shock absorber has slight corrosion to the casing both (2.7.2a)

Suspension component mounting prescribed area is corroded but not considered excessive both sill areas by jacking points (2.4.A.3)

Front Brake hose excessively deteriorated both perished through to cords (3.6.B.4d)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Parking brake: efficiency below requirements (3.7.B.7)

Clutch hydraulic pipe badly coroded

Front both headlamp lenses slightly deteriorated. Image ok

Rear Shock absorber has slight corrosion to the casing both (2.7.2a)

Suspension component mounting prescribed area is corroded but not considered excessive both sill areas by jacking points (2.4.A.3)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Rear Suspension component mounting prescribed area is excessively corroded Inner sill (2.4.A.3)

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Tyre is heavily worn on inner edge

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front brake disc slightly pitted (3.5.1h)

Offside Front brake disc slightly pitted (3.5.1h)