2004 Honda Civic

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Emissions unable to be completed (8.2.1.2 (d))

Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))

Exhaust emissions - engine idle speed too high (8.2.1.2 (e))

Exhaust emits visible black smoke at idle (8.2.1.2 (f))

Nearside Front Inner Suspension arm pin or bush excessively worn front (5.3.4 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Nearside Rear Bumper insecure (6.1.4 (a) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp lens seriously defective (4.1.1 (b) (ii))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced floor to sill holed (7.1.1 (a) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Emissions not tested (8.2.1.2 (d))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

no cat fited

Steering linkage has slight play

Suspension arm pin or bush worn but not resulting in excessive movement Both front lower inner (5.3.4 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Steering linkage has slight play

Suspension arm pin or bush worn but not resulting in excessive movement Both front lower inner (5.3.4 (a) (i))

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

exhaust noise level very loud

hand brake high

hand brake only just met imbalance efficiency

o/s/r hand brake lever pulled forward

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Exhaust catalytic converter missing where one was fitted as standard (7.1.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Parking brake: efficiency below requirements (3.7.B.7)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

exhaust noise level very loud

hand brake high

o/s/r hand brake lever pulled forward

Exhaust noisy (7.1.4)

Offside Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

both rear calipers not returning fully on handbrake lever

nearside front headlight output poor

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

e.m.l on

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Stop lamp not working (1.2.1b)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Registration plate lamp not working (1.1.C.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

e.m.l on

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Rear Front position lamp(s) not working (1.1.A.3b)

Offside Stop lamp not working (1.2.1b)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

rear exhaust box mounting broken but still supported

Front Tyre worn close to the legal limit (4.1.E.1)

plastic sill covers fitted