2001 Peugeot 206

Nearside Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

engine managment light on

Nearside Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Stop lamp not working (1.2.1b)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

engine managment light on

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Wheel/tyre protruding beyond wheel arch

airbag light flickered on at time off test but not constant

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Stop lamp not working (1.2.1b)

Wheel/tyre protruding beyond wheel arch

airbag light flickered on at time off test but not constant

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

air bag light staying on showing fault

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Offside Front Lower Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Rear Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Offside Rear position lamp(s) not working (1.1.A.3b)

Rear Exhaust system not adequately supported (7.1.1)

Registration plate lamp not working (1.1.C.1d)

Offside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

air bag light staying on showing fault

Inner Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Headlamp aim too high (1.8)

Offside Front Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Rear Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

slight blow from centre box...rear box corroded and knocking...slight play and wear in both front lower arm inner bushes...o/s/f tyre getting low on inner edge...knock from n/s when driven over brake rollers

Exhaust has a minor leak of exhaust gases (7.1.2)

Headlamp aim too high (1.8)

Nearsidse rear inner tyre wall cracked

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside rear brake pad on approx 2-3mm

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearsidse rear inner tyre wall cracked

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside rear brake pad on approx 2-3mm

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)