2001 Piaggio Vespa

Offside Motorcycle structure is corroded but structural rigidity is not significantly reduced floor (6.1.1 (c) (i))

Offside Front Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Kickstart lever hanging down.

Front Tyre old and beginning to crack. No cords are visible.

Rear Tyre starting to perish

Rear tyre perishing

Riders seat slightly loose (6.2.5 (a) (ii))

Centre stand doesn't fully retract

Front Shock absorber has slight external damage to the casing (5.3.2 (b))

Front Tyre starting to perish

General surface corrosion to frame

Rear Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Centre stand slack in its upward position. (Hangs slightly)

Rear swing arm, front bushes starting to perish

Seat Loose, but secure.

Wheel alignment slightly misaligned (2.4 (a))

Front Brake lever has insufficient reserve travel (1.1.2 (a))

Rear Tyre has a lump caused by separation or partial failure of its structure (4.1.2a(ii))

Front suspension assembly slightly misaligned (2.3.1)

Direction indicators not working (1.5.1c)

Front Brake disc(s) slightly scored (3.2.A1l)

Front wheel bearings have slight free play (2.3.5b)

Front wheel bearings have slight free play (2.3.5b)

Rear Brake disc(s) slightly scored (3.2.A1l)

Front Brake disc(s) slightly scored (3.2.A1l)

Front wheel bearings have slight free play (2.3.5b)

Registration plate insecure (6.3.1b)

Front Brake disc(s) slightly scored (3.2.A1l)

Front wheel bearings have slight free play (2.3.5b)

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Steering movement excessively 'notchy' with the weight on the lower bearing (2.2.1a)

Exhaust is leaking and excessively noisey (7.1.1b)

Nearside Handlebar handgrip not secure to handlebars. (2.1.1c) DANGEROUS

Rear shock absorber has inadequate damping effect. (2.4.A.3b) DANGEROUS

Rear shock absorber seal failed and leaking oil (2.4.A.1c) DANGEROUS

Front wheel bearings have slight free play (2.3.5b)

Rear suspension bush deteriorated but not excessively (2.4.A2a(i))

Nail in rear tyre

Front Headlamp aim too low when the centre of the headlamp is above 850mm from the ground (1.6.3)