2006 Peugeot 107

Both headlamp beams slightly out of focus.

Rear Brake pipe corroded, covered in grease or other material both sides of car (1.1.11 (c))

Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sills,chassis and floor,both sides of car (5.3.6 (a) (i))

Rear Passenger seat(s) missing at time of test both sides ()

Front Inner Tyre has ply or cords exposed edges both siodes of car (5.2.3 (d) (ii)) DANGEROUS

Both headlamp glasses dull and beams slightly out of focus.

Front Brake pad(s) wearing thin both sides (1.1.13 (a) (ii))

Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sills both sides (5.3.6 (a) (i))

Rear Exhaust mounting defective (6.1.2 (a))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Body has a projection caused by damage (6.1.C.1)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high (1.8)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

front brake pads are worn and have uneven discs surface's

Horn not working (1.6.2a)