2003 Aprilia RS125

Brake pad(s) (sintered type) less than 1.0mm thick (3.2A1f(ii))

Direction indicators not working (1.5.1c)

Lower Rear suspension bush has excessive free play (2.4.A2a(i))

Rear Brake disc(s) excessively scored (3.2.A1l)

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Roller brake test The less effective brake control does not achieve an efficiency of 25%. (3.3.A2b)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.2a(i))

Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

n/s switch gear loose

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front wheel bearings are excessively rough (2.3.5b)

Fuel hose leaking (7.2.1a)

Headlamp aim not tested (1.6)

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Offside Handlebar mounting clamp bolt loose (2.1.1a)

Rear Tyre fouling another component (4.1.4)

Rear Tyre has ply or cord exposed (4.1.2a(iii)

Rear mono-shock pivot seized (2.4.B.4)

Front Brake disc(s) slightly pitted (3.2.A1l)

Rear Brake component worn but not seriously reduced in strength (3.2.A1)

Rear Brake disc(s) slightly scored (3.2.A1l)

Rear Motorcycle structure slightly damaged (6.1.1a)

Gear lever worn

Front Brake lever is so short and the brake cannot be readily applied (3.1.3c)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Headlamp at least one does not illuminate on main beam (1.2.2a(ii))

Horn not working (1.7.3a)

Nearside Front Handlebar mounting clamp bolt loose (2.1.1a)

Offside Front Handlebar mounting clamp bolt loose (2.1.1a)

Rear Footrest missing (6.2.1a)

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear Brake pedal is bent but brake can still be readily applied (3.1.3c)

Nearside Fairings insecure but not likely to impede the steering (2.1.2e)

Rear Brake pedal is bent but brake can still be readily applied (3.1.3c)

horn switch moved to r/h side handlebar

Front Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Nearside Front Direction indicators not working (1.5.1c)

Nearside Handlebar deformed (2.1.1b)

Nearside Handlebar mounting clamp bolt loose (2.1.1a)

Rear Hydraulic brake control feels spongy (3.1.4a)

Nearside Fairings insecure but not likely to impede the steering (2.1.2e)

Rear Brake pedal is bent but brake can still be readily applied (3.1.3c)

horn switch moved to r/h side handlebar