2004 Iveco Daily 35C15 Mwb

Nearside Rear Rear reflector defective or damaged by up to 50% of the reflecting surface (4.8.1 (a) (i))

Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Nearside and Offside (5.3.4 (a) (i))

Brake performance unable to be tested Vehicle not starting (1.2.1 (g))

Inner Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Nearside and Offside (6.2.2 (d) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced X2 (6.1.1 (c) (i))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Front Inner Cab steps so insecure it is likely to cause injury and wheel arch area (6.2.8 (a) (ii))

Offside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Wheel arch area (6.2.2 (d) (i))

Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Nearside and Offside, Inner and Outer (6.2.2 (d) (i))

Nearside Rear Rear reflector defective or damaged by up to 50% of the reflecting surface (4.8.1 (a) (i))

Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Nearside and Offside (5.3.4 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Brake performance not tested brakes stuck on (1.2.1 (g))

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner wing (6.1.1 (c) (i))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outriggers (6.1.1 (c) (i))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner wing (6.1.1 (c) (i))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outriggers (6.1.1 (c) (i))

Central Rear Brake load sensing valve missing where fitted as standard lever arm missing (1.1.17 (d)) DANGEROUS

Nearside Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security fuel filler neck bracket has corroded and hole in side near sill (6.2.2 (d) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing cracking in side wall (5.2.3 (d) (ii))

Offside Front Tyre worn close to legal limit/worn on edge close to limit (5.2.3 (e))

Front Brake pipe excessively corroded brake pipe under bonnet going from servo to under van (1.1.11 (c))

Nearside Front Brake pipe excessively corroded brake pipe going from flexile pipe to under bonnet (1.1.11 (c))

Nearside Rear Direction indicator incorrect colour (4.4.3 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security fuel filler neck bracket has corroded and hole in side near sill (6.2.2 (d) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing cracking in side wall (5.2.3 (d) (ii))

Offside Front Tyre worn close to legal limit/worn on edge close to limit (5.2.3 (e))

Nearside Rear Brake pad(s) contaminated DISC AND PADS COVERED IN OIL (1.1.13 (b))

n/s/r hub seal starting to need changing soon

no warning lights on dash time of test

under trays fitted unable to fully inspect

wheel trims fitted alround

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Direction indicator slightly discoloured (1.4.A.2f)

Nearside Rear reflector slightly damaged but function not impaired (1.5.1c)

Power steering component(s) has slight seepage from a component Rack (2.3.3b)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Direction indicator slightly discoloured (1.4.A.2f)

Nearside Rear reflector slightly damaged but function not impaired (1.5.1c)

Power steering component(s) has slight seepage from a component Rack (2.3.3b)

Steering system excessively tight (2.2.D.1)

Battery insecure (1.9.1)

Brake load sensing valve inoperative (3.6.E.3)

Brake master cylinder/servo mounting prescribed area is excessively corroded (3.6.C.3)

Brake pipe excessively corroded 3 pipes at lsv (3.6.B.2c)

Brake pipe excessively corroded n/s front to rear (3.6.B.2c)

Brake pipe excessively corroded n/s to o/s/f (3.6.B.2c)

Driver's seat fore and aft adjustment mechanism not functioning as intended. (6.2.A.3)

Driver's seat insecure (6.2.A.1)

Exhaust has a major leak of exhaust gases (7.1.2)

Horn not working (1.6.2a)

Nearside Front Brake pipe excessively corroded to flexi (3.6.B.2c)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Rear Brake pipe excessively corroded to flexi (3.6.B.2c)

Nearside Rear Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Nearside Rear Suspension component mounting prescribed area is inadequately repaired (2.4.A.3)

Nearside Rear Upper Leaf spring has excessive wear in a shackle pin and/or bush (2.4.B.2)

Nearside Rear brake disc contaminated by oil (3.5.1h)

Offside Front Lower Shock absorber insecure (2.7.2b)

Offside Front Seat belt anchorage prescribed area is fractured (5.2.6)

Offside Headlamp aim too low (1.8)

Offside Rear Brake pipe excessively corroded to flexi (3.6.B.2c)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear Suspension component mounting prescribed area is excessively corroded arb (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is inadequately repaired (2.4.A.3)

Offside Rear Upper Leaf spring has excessive wear in a shackle pin and/or bush (2.4.B.2)

Parking brake: efficiency below requirements (3.7.B.7)

Passenger's seat insecure (6.2.A.1)

Nearside Rear Rear reflector slightly damaged but function not impaired (1.5.1c)

Power steering component(s) has slight seepage from a component (2.3.3b)

Steering system slightly tight (2.2.D.1)

slight under body corrosion

Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

front wipers

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

front wipers

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

n/s sliding door not closed correctly

o/s/f chassis rubber mount is damaged

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Brake pedal anti-slip provision worn smooth (3.3.A.1b)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

n/s sliding door not closed correctly

o/s/f chassis rubber mount is damaged

Nearside Rear Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Rear Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Rear Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Rear Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear fog lamp not working (1.3.2b)

Rear fog lamp tell tale not working (1.3.1b)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Headlamp aim too high (1.8)

Nearside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Headlamp aim too high (1.8)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Rear Direction indicator incorrect colour (1.4.A.2f)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Registration plate lamp not working (1.1.5c)

Nearside sidemarker light lens broken and light not working

Offside wiperblade starting to split