2005 Yamaha YBR125

Wheel alignment slightly misaligned (2.4 (a))

Rear Brake component insecure (1.1.21 (c))

Rear Drive chain sprocket excessively loose (6.1.7 (c) (i))

Wheel alignment slightly misaligned (2.4 (a))

Drive chain slightly loose (6.1.7 (c) (i))

Front Brake binding but not excessively (1.2.1 (f))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front brake pads may need replacing

Front indicators faded

Front upper fork legs some pitting

Headlamp light intensity reduced pattern deteriated (4.1.4 (a))

Drive chain slightly tight (6.1.7 (k) (i))

Exhaust noisy (8.1.1 (a))

Front suspension soft

some pitting on fork legs

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Suspension arm ball joint worn, but not excessively Swinging arm pivot. (5.3.4 (a) (i))

Steering operation restricted in free movement from lock to lock (2.1.4 (c))

Suspension arm ball joint worn, but not excessively Swinging arm pivot. (5.3.4 (a) (i))

Steering movement slightly 'notchy' (2.2.1a)

l/h handlebar slightly bent.

Drive chain excessively loose (6.2.1d)

Headlamp aim too high (1.6)

Offside Footrest insecure passanger (6.2.1a)

Rear suspension bush has excessive free play swingarm (2.4.A2a(i))

Exhaust slightly deteriorated (7.1.1a)

Front Brake lever pivots slightly worn (3.1.3a)

Nearside Front shock absorber has light misting of stanchion (2.3.3)

bolt missing from front brake lever clamp, but secure at this time.

clutch lever pivot worn.

rear brake plate slightly broken.

Brake pedal cannot be released smoothly (3.1.3d)

Drive chain excessively loose (6.2.1d)

Drive chain worn to excess (6.2.1e)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front Floor brake test indicates a binding brake (3.3.C2c)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear Floor brake test indicates a sticking brake (3.3.C2c)

Rear Tyre has a tear caused by separation or partial failure of its structure (4.1.2a(ii))

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear reflector on motorcycle missing (1.4.1)

Rear suspension bearing has excessive free play (2.4.A2a(i))

Wheel alignment incorrect which adversely affects the handling (2.5.1)

Exhaust slightly deteriorated (7.1.1a)

Front Brake lever pivots slightly worn (3.1.3a)

Nearside Front shock absorber has light misting of stanchion (2.3.3)

bolt missing from front brake lever clamp, but secure at this time.

clutch lever pivot worn.

rear brake plate slightly broken.

Drive chain slightly loose (6.2.1d)

Exhaust is leaking but is not excessively noisey (7.1.1b)

Rear Drive chain sprocket slightly worn (6.2.1e)