2003 Hyundai Getz

both rear metal brake pipes rusty

engine seeping oil

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength door sill (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength subframe (5.3.6 (a) (i))

both rear metal brake pipes rusty

engine seeping oil

Headlamp aim projected beam image is obviously incorrect both front (4.1.2 (c))

Registration plate does not conform to the specified requirements front and rear (0.1 (d))

Service brake grabbing severely both rear (1.2.1 (c))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Emissions not tested (7.3.A.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Exhaust has a minor leak of exhaust gases Flexy front pipe to centre section joint (7.1.2)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt link pin (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Front Tyre worn close to the legal limit worn on both edges (4.1.E.1)

Offside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (7.1.4)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Stop lamp not working (1.2.1b)

Offside Rear position lamp(s) not working (1.1.A.3b)

Offside Stop lamp not working (1.2.1b)

Offside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Nearside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

both rear tyres deteriorating

exhaust deteriorating & slight leak

n/s/r tyre worn on edges close to limits

rear wiper not clearing

Nearside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

both rear tryes deteriorating, n/s/r tyre worn on edges

exh flexi slight leak

rear brake imb high & slight judder

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Registration plate lamp not working (1.1.C.1d)

Rear fog lamp not working (1.3.2b)

Offside Front Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1) DANGEROUS

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Nearside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

both rear tryes deteriorating, n/s/r tyre worn on edges

rear brake imb high & slight judder

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Headlamp not working on dipped beam (1.7.5a)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Nearside Registration plate lamp not working (1.1.5c)

Offside Registration plate lamp not working (1.1.5c)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)