2005 Fiat Doblo

Central Rear Engine mounting bracket damaged or deteriorated resulting in excessive movement (6.1.8 (a) (i))

Fuel cap/sealing device missing (6.1.3 (b) (i))

Nearside Direction indicator not working Side repeater (4.4.1 (a) (ii))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Macpherson strut pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Headlamp aim too high (4.1.2 (a))

Central Front Fuel pipe leaking excessively or a risk of fire (6.1.3 (b) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Brake warning device malfunctioning or defective (1.1.4 (a) (i))

Central Rear corroded chassis

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Nearside Side repeater lens defective which has no effect on emitted light Lens missing (4.4.1 (b) (i))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front drivers door damaged, door stopper missing

Offside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust emissions exceed level of metered smoke for a turbo charged engine (8.2.2.2 (b))

Fuel cap/sealing device missing (6.1.3 (b) (i))

Nearside Rear Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Power steering pipe/hose leaking (2.1.5 (a))

Windscreen in an unacceptable condition (3.2 (c) (i))

Windscreen washer not working (3.5 (a))

Fuel system component leaking excessively or a risk of fire (6.1.3 (b) (ii)) DANGEROUS

Nearside Rear Suspension component missing bump stop. (5.3.3 (a) (ii)) DANGEROUS

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Nail in tyre ()

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Parking brake lever has no reserve travel (3.1.6b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Parking brake lever has little reserve travel (3.1.6b)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nail in nearside rear tyre

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

drivers door check strap missing

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nail in nearside rear tyre

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

drivers door check strap missing

Centre Rear Stop lamp not working (1.2.1b)

Nearside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Exhaust emits an excessive level of metered smoke for a non-turbo charged engine (7.4.B.3b)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside rear brake recording little or no effort (3.7.B.5a)

Service brake: efficiency below requirements (3.7.B.7)

Power steering component(s) has slight seepage from a component (2.3.3b)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Headlamp not working on dipped beam (1.7.5a)