2009 Jinlun Jl

Front Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Nearside Rear Wheel alignment slightly misaligned cant be adjusted up any more (2.4 (a))

Registration plate slightly loose (0.1 (a))

no lights tested at time of test

Brake reaction bracket excessively worn s/pin missing (1.1.15 (b))

Front Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Nearside Rear Wheel alignment slightly misaligned cant be adjusted up any more (2.4 (a))

Rear Wheel alignment incorrect which adversely affects the handling (2.4 (a))

Registration plate slightly loose (0.1 (a))

no lights tested at time of test

Central Front Headlamp aim projected beam image obviously incorrect (4.1.2 (c))

Rear Stop lamp not working no rear brake switch fitted (4.3.1 (a) (ii))

Front Stop lamp not working (4.3.1 (a) (ii))

Rear Brake excessively binding (1.2.1 (f))

Rear Footrest missing (6.2.12 (a))

Rear Stop lamp not working (4.3.1 (a) (ii))

Rear Wheel alignment incorrect which adversely affects the handling (2.4 (a))

Roller brake test The less effective brake control does not achieve an efficiency of 25% (1.2.2 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Nearside Front Tyre worn close to the legal limit cracking on side wall (5.2.3 (e))

Roller brake test The less effective brake control does not achieve an efficiency of 25% (1.2.2 (a) (i))

Offside Rear Exhaust noisy (8.1.1 (a))

Brake performance not tested rear brake seized on (1.2.1 (g))

Headlamp aim too low headlight loose (4.1.2 (a))

Rear Stop lamp adversely affected by the operation of another lamp does not illuminate brighter when tail light also activated (4.3.3 (b))

Rear Stop lamp not working rear pedal switch not working (4.3.1 (a) (ii))

Rear reflector missing (4.8.2 (a) (ii))

Throttle operating incorrectly cable not seated in adjuster bracket (6.2.7 (a) (i))

Rear Mudguard insecure ()

Exhaust noisy due to only running on one pot (8.1.1 (a))

Front Brake binding but not excessively (1.2.1 (f))

Front Brake excessively binding (1.2.1 (f))

Front Brake lever is positioned so that the brake cannot be readily applied switch gear loose (1.1.2 (d))

Exhaust noisy due to only running on one pot (8.1.1 (a))

gear lever pivot slightly worn

Nearside Drive chain slightly loose (6.1.7 (c) (i))

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

No front mudguard fitted

lights masked off at time of test ,daylight use only while lights are masked off

Front wheel bearings are excessively rough (2.3.5b)

Front wheel bearings have excessive free play (2.3.5b)

Drive chain slightly loose (6.2.1d)

offside starter and light conrol loose

advise offside starter and light control loose