2004 Honda Stepwagon

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Coil spring corroded both rear (5.3.1 (b) (i))

Headlamp lens slightly defective both (4.1.1 (b) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Offside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

All brake discs slightly rusty on surface areas.

Offside Suspension component mounting prescribed area is corroded but not considered excessive inner arch. (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive under side of vehicle ,chassis rail o/s/f,both inner sill panels,various areas under side. (5.3.6 (a) (i))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength chassis rail. (5.3.6 (a) (i))

All brake discs slightly rusty on surface areas.

Offside Suspension component mounting prescribed area is corroded but not considered excessive inner arch. (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive under side of vehicle ,chassis rail o/s/f,both inner sill panels,various areas under side. (5.3.6 (a) (i))

Nearside Front Upper Subframe mounting prescribed area excessively corroded significantly reducing structural strength on chassis rail. (5.3.6 (a) (i))

Offside Front Coil spring fractured or broken at lower section. (5.3.1 (b) (i))

Nearside Front Upper Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive inner arch. (5.3.6 (a) (i))

Rust present under side of vehicle.

Suspension component mounting prescribed area is corroded but not considered excessive Both inner sill panels. (5.3.6 (a) (i))

Front both front chassis legs corroded at joint

Nearside Front inner wheel arch corroded by subframe mount area

Nearside inner sill corroded front to rear

Offside Front Inner inner sill corroded front to rear

Offside Front inner wheel arch corroded by brake pipe mountin area

Offside Rear chassis corroded above tank

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front both front chassis legs corroded at joint

Nearside Front inner wheel arch corroded by subframe mount area

Nearside inner sill corroded front to rear

Offside Front Inner inner sill corroded front to rear

Offside Front inner wheel arch corroded by brake pipe mountin area

Offside Rear chassis corroded above tank

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Integral body structure is corroded but structural rigidity is not significantly reduced under body (6.1.1 (c) (i))

Nearside Front Tyre worn close to legal limit/worn on edge on edges (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge on edges (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge on edges (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge on edges (5.2.3 (e))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Upper Sub-frame corroded to the extent that the rigidity of the assembly is significantly reduced mount to chassis holed (6.1.1 (c) (i))

Nearside Rear Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Offside Front Position lamp not working (4.2.1 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Integral body structure is corroded but structural rigidity is not significantly reduced under body (6.1.1 (c) (i))

Nearside Front Tyre worn close to legal limit/worn on edge on edges (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge on edges (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge on edges (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge on edges (5.2.3 (e))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))