2003 Mercedes-benz Vito

Front Registration plate inscription illegible (0.1 (b))

Front Registration plate insecure (0.1 (a))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength jacking point area (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Nearside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength crossember (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength jacking point (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength jacking point (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength crossember (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

drivers seat poor condition

under seal under vehicle

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Integral body structure is corroded but structural rigidity is not significantly reduced under body inner sill panel (6.1.1 (c) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Inner Integral body structure is corroded but structural rigidity is not significantly reduced sill panel (6.1.1 (c) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

drivers seat in poor condtion

Nearside Rear Suspension component mounting prescribed area is inadequately repaired (5.3.6 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Integral body structure is corroded but structural rigidity is not significantly reduced under body inner sill panel (6.1.1 (c) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Inner Integral body structure is corroded but structural rigidity is not significantly reduced sill panel (6.1.1 (c) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

drivers seat in poor condtion

Oil leak, but not excessive (8.4.1 (a) (i))

corrosion to nearside and offside front chassis areas within prescribed areas of subframe mountings

corrosion to nearside and offside front inner sill/jacking point areas outside of prescribed areas

corrosion to nearside rear inner sill areas within suspension prescribed areas

corrosion to offside rear chassis areas and inner sill areas within suspension prescribed areas

drivers door interior panelling is missing

front and rear number plates are deteriorating but not likely to be misread

nearside and offside front headlamp aims do not appear to adjust up and down very much with driver controlled height adjuster

nearside front tyre is wearing unevenly/feathering on inner edge

nearside rear number plate lamp not working

nearside side loading door does not appear to open

offside rear front to rear metal brake pipe is corroding

rear foot brake load compensator vale is starting to seize up

severe corrosion to nearside inner sill areas within seatbelt prescribed areas

slight damage to windscreen but does not affect drivers view

slightly low effort to nearside rear handbrake

spare wheel is missing from carrier, carrier is secure

Nearside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill area (7.1.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis rail (5.3.6 (a) (i))

Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch area (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is inadequately repaired sill end closure area (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

corrosion to nearside and offside front chassis areas within prescribed areas of subframe mountings

corrosion to nearside and offside front inner sill/jacking point areas outside of prescribed areas

corrosion to nearside rear inner sill areas within suspension prescribed areas

corrosion to offside rear chassis areas and inner sill areas within suspension prescribed areas

drivers door interior panelling is missing

front and rear number plates are deteriorating but not likely to be misread

minor damages to wiring harness under centre nearside of vehicle

nearside and offside front headlamp aims do not appear to adjust up and down very much with driver controlled height adjuster

nearside front tyre is wearing unevenly/feathering on inner edge

nearside rear number plate lamp not working

nearside side loading door does not appear to open

offside rear front to rear metal brake pipe is corroding

rear foot brake load compensator vale is starting to seize up

severe corrosion to nearside inner sill areas within seatbelt prescribed areas

slight damage to windscreen but does not affect drivers view

slightly low effort to nearside rear handbrake

spare wheel is missing from carrier, carrier is secure

Driver's door cannot be opened from inside the vehicle (6.2.3 (a))

Nearside Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting side sill (6.2.2 (d) (i))

Nearside Rear Lower Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced panel (6.1.1 (c) (i))

Nearside Side repeater incorrect colour (4.4.3 (a))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Obligatory mirror insecure (3.3 (b) (ii))

Offside Rear Lower Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced panel (6.1.1 (c) (i))

Offside Side repeater incorrect colour (4.4.3 (a))

Offside Track rod end ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

rust to rear valance behind bumper

Nearside Front Service brake excessively fluctuating (1.2.1 (e))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill area (6.1.1 (c) (i))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill areas (6.1.1 (c) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

rust to rear valance behind bumper

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Offside Rear tyre cracked

Oil leak ()

Nearside Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Subframe mounting prescribed area is excessively corroded inner sill areas (2.4.A.3)

Offside Front Subframe mounting prescribed area is excessively corroded inner sill area (2.4.A.3)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Subframe mounting prescribed area is excessively corroded inner sill areas (2.4.A.3)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Offside Rear tyre cracked

Oil leak ()

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside rear brake excessively fluctuating (3.7.B.3)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Front Subframe mounting prescribed area is excessively corroded Jacking point (2.4.A.3)

Offside rear brake recording little or no effort (3.7.B.5a)

Rear brake disc in such a condition that it is seriously weakened (3.5.1i)

Rear registration plate delaminated but not likely to be misread (6.3.1d)

Brake load sensing valve linkage seized (3.6.E.3)

Rear registration plate delaminated but not likely to be misread (6.3.1d)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Nearside Headlamp aim too low (1.8)

Nearside Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Offside Headlamp aim too low (1.8)

Parking brake lever has no reserve travel (3.1.6b)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Nearside Front Anti-roll bar synthetic bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

damage to n/s wing mirror

n/s/r tyre cracking in side wall

Offside Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Offside Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear rear brake recording little or no effort (3.7.B.5a)

Offside Stop lamp not working (1.2.1b)

Parking brake: efficiency below requirements (3.7.B.7)

o/s/f inner cv boot split

wing mirror cover insecure

Nearside Front Anti-roll bar linkage insecure (2.4.G.1)

Nearside Rear Direction indicator incorrect colour (1.4.A.2f)

Nearside Stop lamp not working (1.2.1b)

Offside Front Anti-roll bar linkage insecure (2.4.G.1)

Parking brake: efficiency below requirements (3.7.B.7)

o/s/f inner cv boot split

wing mirror cover insecure

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

n/s door morror glass cracked

Horn not working (1.6.2a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

n/s door morror glass cracked

accident damage to n/s wing mirror

Nearside front inner cv boot split

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside front inner cv boot split

Emissions not tested (7.0)