2008 Honda Civic

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

car leaking coolant carstop middel of test

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Headlamp lens slightly defective both (4.1.1 (b) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced both inner and outer sills (6.1.1 (c) (i))

Parking brake lever defective but can be satisfactorily operated (1.1.6 (d))

Rear Suspension arm corroded but not seriously weakened both (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Suspension arm pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Headlamp lens slightly defective both (4.1.1 (b) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced both inner and outer sills (6.1.1 (c) (i))

Rear Suspension arm pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Suspension arm pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Headlamp lens slightly defective both (4.1.1 (b) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced both inner and outer sills (6.1.1 (c) (i))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Rear Suspension arm pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both (5.3.6 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Headlamp lens slightly defective both (4.1.1 (b) (i))

Headlamp lens slightly defective both (4.1.1 (b) (i))

Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Rear Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Headlamp aim too low both (4.1.2 (a))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Headlamp aim too low (1.8)

Parking brake lever has little reserve travel (3.1.6b)

park brake low effort low both sides

Offside Front Tyre tread depth below requirements of 1.6mm inner edge (4.1.E.1)

Parking brake lever has little reserve travel (3.1.6b)

park brake low effort low both sides

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front wheel bearing has excessive play (2.5.A.3c)

Nearside Stop lamp not working (1.2.1b)

Offside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Parking brake lever has little reserve travel (3.1.6b)

Steering system has slight free play detected at steering wheel (2.2.A.1b)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

rear brake application uneven (3.7.B.2)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nail in nearside front tyre

Nearside Front Track rod end ball joint has slight play (2.2.B.1f)