2013 Peugeot 208

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside rear tyre starting to go out of shape

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Nail in tyre ()

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Front tyre tread wearing low(2mm) and edge worn lower.

exhaust rear pipe mount missing

Nearside Front tyre tread wearing low(2mm) and edge worn lower.

Offside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

exhaust rear pipe mount missing