1992 Mercedes-benz S-class

Offside Rear Outer Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Front Lower Shock absorbers insecurely attached bolt missing (5.3.2 (a) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Headlamp aim too high (4.1.2 (a))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Inner Subframe mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Offside Front Subframe mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Back plate slightly insecure.

Oil leak, but not excessive (8.4.1 (a) (i))

Steering box has seepage (2.1.1 (e) (i))

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Rear Hydraulic brake calliper leaking (1.1.16 (b) (i))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Prop shaft bearing excessively worn (6.1.7 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Front Back plate slightly insecure.

Oil leak, but not excessive (8.4.1 (a) (i))

Steering box has seepage (2.1.1 (e) (i))

offside front inner wing corroded but not affecting structural integrity

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Road wheel fixing missing (5.2.1 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sub frame bracket (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sub frame bracket (5.3.6 (a) (i))

offside front inner wing corroded but not affecting structural integrity

coil spring corroded (2.4.C.1b)

Brake pipe excessively corroded (3.6.B.2c)

Front Brake pipe leaking (3.6.A.1)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Brakes imbalanced across an axle (3.7.B.5b)

Centre Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Intermediate drop arm fractured and unserviceable (2.2.C.1d)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside rear brake recording little or no effort (3.7.B.5a)

front and rear brake pipes corroded †slight play in o/s/f track rod end †req front prop coupling,split