1992 Toyota MR2

Driver's airbag missing (7.1.5 (a))

Nearside Front Direction indicator incorrect colour (4.4.3 (a))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Rear side of inner wheel arch (6.1.1 (c) (i))

Nearside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Nearside Side repeater not working (4.4.1 (a) (ii))

Offside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Macpherson strut pin or bush excessively worn Top mount (5.3.4 (a) (i))

Offside Rear Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Inner sill/wheel arch area (6.1.1 (c) (i))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Rear side of inner wheel arch (6.1.1 (c) (i))

Windscreen washer not working (3.5 (a))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

General underbody corrosion

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Suspension arm damaged but not seriously weakened Trailing arm bent (5.3.3 (b) (i))

Oil leak, but not excessive Offside rear driveshaft seal leaking (8.4.1 (a) (i))

Radiator fan loose

Emissions not tested (8.2.1.2 (d))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Horn not working (7.7 (a) (ii))

Nearside Front Service brake excessively binding (1.2.1 (f))

Offside Front Service brake excessively binding (1.2.1 (f))

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Front Bumper mountings corroded but not likely to become detached panel by radiator (6.1.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Parking brake lever defective but can be satisfactorily operated (1.1.6 (d))

Emissions not tested (7.4.B.1)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Nearside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings outer sill (6.1.B.2)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Rear position lamp(s) not working (1.1.A.3b)

Rear fog lamp not working (1.3.2b)

Registration plate lamp not working (1.1.C.1d)

NS outer sill corroded

Offside Brake pad(s) wearing thin (3.5.1g)

Offside Rear Tyre has ply or cords exposed (4.1.D.1b)

NS outer sill corroded

Offside Brake pad(s) wearing thin (3.5.1g)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Steering wheel locking device insecure (2.1.6)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

1 x nut missing on o/s engine mount

Exhaust noisy (7.1.4)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Outer Rear Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

n/s handbrake cable not routed through cable support

o/s/f lower wing insecure

Front registration plate with character(s) which are not the correct height (6.3.4a)

Nearside Headlamp aim too high (1.8)

Nearside Inner Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Outer Rear Lower Suspension arm locating pin retaining device missing (2.4.G.3b)

Nearside Outer Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Nearside Seat belt insecurely fixed to the seat (5.2.1a)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp aim too high (1.8)

Offside Inner Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Outer Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Outer Rear Suspension component mounting prescribed area is inadequately repaired (2.4.A.3)

Offside Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Offside Seat belt insecurely fixed to the seat (5.2.1a)

1 x nut missing on o/s engine mount

Exhaust noisy (7.1.4)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Outer Rear Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

n/s handbrake cable not routed through cable support

o/s/f lower wing insecure

Gearbox mounting defective

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Spare tyre defective

Under-trays fitted obscuring some underside components

spare wheel insecure but spare wheel in boot

under body rusty all areas

Nearside Headlamp aim too low (1.8)

Nearside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Steering rack gaiter split (2.2.D.2d)

Offside Front front brake binding (3.7.B.1)

Offside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Rear Rear wheel bearing has excessive play (2.6.2) DANGEROUS

Brake hydraulic reservoir fluid level below minimum level (3.6.G.1b)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Under-trays fitted obscuring some underside components

front lower vallance insecure

under body rusty all areas

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Steering wheel retaining device insecure (2.1.6)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Parking brake lever has no reserve travel (3.1.6b)

Brakes imbalanced across an axle (3.7.B.5b) DANGEROUS

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Suspension component mounting prescribed area is fractured (2.4.A.3)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Stop lamp not working (1.2.1b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Rear Stop lamp not working (1.2.1b)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Registration plate lamp not working (1.1.5c)

Suspension component mounting prescribed area is fractured (2.4.A.3)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)