1992 Toyota MR2

noisy aftermarket exhaust fitted - not considered excessive

Front Brakes imbalanced across an axle (3.7.B.5b)

Offside rear parking brake recording little or no effort (3.7.B.6a)

noisy aftermarket exhaust fitted - not considered excessive

Offside Front Suspension component mounting prescribed area is inadequately repaired (2.4.A.3)

Offside Rear wheel bearing has excessive play (2.6.2)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

vehicle fitted with noisy aftermarket exhaust - not considered excessive

Battery insecure (1.9.1)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Rear Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside front brake binding (3.7.B.1)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Direction indicator excessively deteriorated so that it is not visible from a reasonable distance (1.4.A.2e)

Offside Rear Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Rear Suspension arm severely distorted (2.4.G.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

OSF tyre wearing on inner edge

OSR support bar corroded

Nearside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Centre Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Coil spring not correctly located (2.4.C.2)

Nearside Rear Coil spring not correctly located (2.4.C.2)

Offside Front Coil spring not correctly located (2.4.C.2)

Offside Rear Coil spring not correctly located (2.4.C.2)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Front Suspension component mounting prescribed area is fractured (2.4.A.3)

Front registration plate insecure (6.3.1b)

Headlamp aim too low (1.8)

Inner Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Inner Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Offside Obligatory mirror insecure (8.1.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake lever has no reserve travel (3.1.6b)

Registration plate lamp not working (1.1.5c)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Registration plate lamp not working (1.1.5c)

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

brake pads on limit