1991 Honda CB450

Roller brake test The less effective brake control does not achieve an efficiency of 25% (1.2.2 (a) (i))

Rear Tyre has a tear caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Rear Rear reflector missing (4.8.2 (a) (ii))

Rear Registration plate does not conform to the specified requirements (0.1 (d))

Brake fluid low on control 1

Chain condition showing signs of corrosion

Direction indicator flashing more than 120 times a minute (4.4.4 (a))

Nearside Rear Exhaust has a minor leak of exhaust gases down pipe to silencer (6.1.2 (a))

Offside Front Exhaust has a minor leak of exhaust gases down pipe to silencer (6.1.2 (a))

Rear tyre cracking in treaded area

Nearside Front Direction indicator not working (4.4.1 (a) (ii))

Nearside Front Exhaust has a major leak of exhaust gases from engine to manifold (6.1.2 (a))

Rear reflector missing (4.8.2 (a) (ii))

Registration plate does not conform to the specified requirements (0.1 (d))

Central Engine mounting/bracket excessively loose Bolt through the Frame, Engine and Rear suspension arms Loose (6.1.8 (a) (ii)) DANGEROUS

Handlebar grip insecure to handlebar Both Grips (2.2.1 (d) (ii)) DANGEROUS

Stop lamp does not illuminate by the operation of both brake controls (4.3.2 (a) (iii)) DANGEROUS

Brake fluid low on control 1

Chain condition showing signs of corrosion

Direction indicator flashing more than 120 times a minute (4.4.4 (a))

Nearside Rear Exhaust has a minor leak of exhaust gases down pipe to silencer (6.1.2 (a))

Offside Front Exhaust has a minor leak of exhaust gases down pipe to silencer (6.1.2 (a))

Rear tyre cracking in treaded area

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake fluid below minimum mark (1.1.10 (d) (i))

front brakes slightly binding

off side grip torn on handle bars

Fuel system component leaking (7.2.1a)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

front brakes slightly binding

off side grip torn on handle bars

Front Floor brake test indicates a binding brake (3.3.C2c)

Drive chain slightly tight (6.2.1d)

Offside Front shock absorber has light misting of stanchion (2.3.3)

Drive chain slightly tight (6.2.1d)

Front Tyre is incorrectly seated on the wheel rim (4.1.2b)

Offside Front shock absorber has light misting of stanchion (2.3.3)

Rear Brake disc(s) friction surface contaminated by oil or grease (3.2.A1k)

Front Tyre worn close to the legal limit (4.1.3(ii))

Drive chain worn to excess (6.2.1e)

Nearside Front shock absorber seal failed and leaking oil (2.3.3)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))