1992 BMW 316

Front Brake pad(s) wearing thin (3.5.1g)

Nail in nearside rear tyre

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Brake hydraulic reservoir fluid level below minimum level (3.6.G.1b)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Steering rack gaiter split (2.2.D.2d)

Nearside Stop lamp not working (1.2.1b)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Registration plate lamp not working (1.1.C.1d)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Front Brake pad(s) wearing thin (3.5.1g)

Nail in nearside rear tyre

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Exhaust system not adequately supported (7.1.1)

Hazard warning switch faulty (1.4.B.1d)

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Windscreen washer provides insufficient washer liquid (8.2.3)

Battery insecure

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Spare tyre defective

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

both front brake backplates corroded and in poor condition

both wiper blades in poor condition

engine runs unevenly and has very weak mixture

homemade towbar fitted and welded to floor pan

lowering springs fitted to front and rear of vehicle

nearside and offside front jacking points corroded and holed outside prescribed area

offside front inner wing corroded and holed not a prescribed area

offside rear brake hose retained by jubilee clip

rear coil springs corroded

underside of vehicle in poor condition

Brakes imbalanced across an axle (3.7.B.5b)

Battery insecure

Coolant leak

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Spare tyre defective

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

both front brake backplates corroded and in poor condition

homemade towbar fitted and welded to floorpan

lowering springs fitted to front and rear of vehicle

nearside and offside front jacking points corroded and holed outside prescribed area

offside front inner wing corroded and holed not a prescribed area

offside rear brake hose retained by jubilee clip

rear coil springs corroded

underside in poor condition

Brakes imbalanced across an axle (3.7.B.5b)

Emissions not tested (7.0)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Brake hose bulging under pressure (3.6.B.3)

Offside Rear Brake pipe inadequately clipped (3.6.B.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Power steering pipe(s) or hose(s) fouling other parts of the vehicle (2.3.2)

Battery insecure

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Spare tyre defective

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

both front brake backplates corroded and in poor condition

homemade towbar fitted and welded to floor pan

lowering springs fitted to front and rear of vehicle

nearside and offside front jacking points corroded and holed outside prescribed area

offside front inner wing corroded and holed not a prescribed area

offside rear brake hose retained by jubilee clip

offside rear tyre perished

rear coil springs corroded

underside of vehicle in poor condition

corrosion in o/s/f outer flooring. corrosion in o/s/f lower wing.

rear axle dif bearings worn

slight play in steering coloumn

Anti-lock braking system warning lamp does not illuminate (3.4.1b)

Centre Exhaust system not adequately supported (7.1.1)

Headlamps matched pair are not the same colour (1.7.6)

Nearside Front Direction indicators not working (1.4.A.2c)

Offside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Registration plate lamp not working (1.1.5c)

Offside Track rod end ball joint has excessive play (2.2.B.1f)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake lever has no reserve travel (3.1.6b)

Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

corrosion in o/s/f outer flooring. corrosion in o/s/f lower wing.

rear axle dif bearings worn

slight play in steering coloumn

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside front brake juddering slightly (3.7.A.2b)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

mid exhaust mounting rubber getting weak/perished.

o/s/f brake hose secured with cable ties.

rear diff. noisy/rumbling.

rear inner sills getting corroded,would advise spraying with waxoyl/waste oil.

Nearside Front Lower Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front position lamp(s) not in good working order (function impaired) (1.1.4a)

Nearside Headlamp aim too low (1.8)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Nearside Steering rack gaiter split (2.2.D.2d)

Offside Front Lower Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front position lamp(s) not in good working order (function impaired) (1.1.4a)

Offside Front wheel bearing rough when rotated (2.5.A.2)

Offside Headlamp aim too low and too far to the left. (1.8)

Windscreen washer provides insufficient washer liquid (8.2.3)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Steering rack gaiter deteriorated (2.2.D.2d)

Offside front brake juddering slightly (3.7.A.2b)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

alternator lower mounting bolt loose/hanging out.

exhaust heat shield loose/rattling.

mid exhaust mounting rubber getting weak/perished.

o/s/ wiper blade could be longer.bordering on being too short.

o/s/f brake hose secured with cable ties.

o/s/r brake hose retaining clip missing,hose loosely held with cable tie.

rear diff. noisy/rumbling.

rear inner sills getting corroded,would advise spraying with waxoyl/waste oil.

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

baffles loose inside centre exhaust

Nearside Front Lower Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Front Lower Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Power steering pump drive system defective (2.3.6)