1992 Volkswagen Golf

Nearside Front Suspension component mounting prescribed area is excessively corroded floor (2.4.A.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Suspension component mounting prescribed area is excessively corroded floor (2.4.A.3)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Nearside Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

nearside front floor holed

sill trims fitted

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front coil spring incomplete (2.4.C.1a)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

front brake application uneven (3.7.B.2)

Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Nearside Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

all brake pipes greesed/ or rusty

nearside front floor holed

sill trims fitted/ sills covered

Brake pipe slightly corroded (3.6.B.2c)

Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Nearside Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

all tyre's perished

Brakes imbalanced across an axle (3.7.B.5b)

Registration plate lamp not working (1.1.5c)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

both front tyre's perished

both rear tyre's perished

Brake pipe slightly corroded (3.6.B.2c)

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Macpherson strut has slight movement in the upper support bearing assembly (2.5.B.1b)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear wheel bearing has slight play (2.6.2)

Centre Exhaust mounting missing (7.1.1b)

Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Brake pipe slightly corroded (3.6.B.2c)

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Macpherson strut has slight movement in the upper support bearing assembly (2.5.B.1b)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear wheel bearing has slight play (2.6.2)

Brake pipe slightly corroded (3.6.B.2c)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Side repeater not working (1.4.A.2c)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)