1992 Jaguar Xjs

Coil spring corroded all springs (5.3.1 (b) (i))

Exhaust noisy (8.1.1 (a))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Headlamp aim too high (4.1.2 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Coil spring corroded all springs (5.3.1 (b) (i))

Exhaust noisy (8.1.1 (a))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Nearside Rear Road wheel fixing missing wheel nut (5.2.1 (a) (i))

Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Rear Road wheel fixing missing wheel nut (5.2.1 (a) (i))

Offside Side repeater not working (4.4.1 (a) (ii))

Windscreen washer not working (3.5 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

All position lamps light intensity obviously reduced Both rears. (4.2.3 (a) (i))

Nearside Front Headlamp reflector slightly defective (4.1.1 (b) (i))

Nearside Front Sun visor missing

Nearside Rear Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Headlamp reflector slightly defective (4.1.1 (b) (i))

Offside Obligatory mirror slightly loose (3.3 (b) (i))

Oil leak, but not excessive Engine (8.4.1 (a) (i))

Windscreen wiper blade defective Both (3.4 (b) (i))

Brake pipe corroded, covered in grease or other material all pipes (1.1.11 (c))

Body has slight corrosion (6.1.B.2)

Central Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Vehicle structure has slight corrosion (6.1.B.2)

Vehicle structure has slight corrosion (6.1.B.2)

Nearside Front Body has a sharp edge caused by corrosion (6.1.C.1)

Nearside Front Body has a sharp edge caused by corrosion wing (6.1.C.1)

Nearside Front Suspension component mounting prescribed area is excessively corroded shock absorber mount (2.4.A.3)

Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings footwell (6.1.B.2)

Offside Brake pipe excessively corroded front to rear (3.6.B.2c)

Offside Front Suspension component mounting prescribed area is excessively corroded shock absorber mount (2.4.A.3)

Offside Rear Body has a sharp edge caused by corrosion (6.1.C.1)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Body has slight corrosion (6.1.B.2)

Central Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Vehicle structure has slight corrosion (6.1.B.2)

Vehicle structure has slight corrosion (6.1.B.2)

Nearside Front Seat belt anchorage prescribed area is excessively corroded floorpan (5.2.6)

Nearside Front Suspension component mounting prescribed area is excessively corroded wheel arch (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded wheel arch (2.4.A.3)

Offside Side repeater not working (1.4.A.2c)

Parking brake: efficiency below requirements (3.7.B.7)

Both front tyres perished

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement all (2.4.G.2)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

coil spring corroded all (2.4.C.1b)

Centre Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement and offside front bushes splitting (2.4.G.2)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded floor pan (5.2.6)

Offside Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Centre Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement and offside front bushes splitting (2.4.G.2)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive sill panel and floor pan (5.2.6)

Nearside Rear tyre perished and inner side wall split

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Battery insecure (1.9.1)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front wheel bearing has excessive play (2.5.A.3c)

Nearside Front wheel bearing rough when rotated (2.5.A.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside rear brake binding (3.7.B.1)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside rear brake binding (3.7.B.1)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

rear brake application uneven (3.7.B.2)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Side repeater not working (1.4.A.2c)

Parking brake: efficiency below requirements (3.7.B.7)

nsr tyre perrished

Nearside Front Headlamp aim too high and too far to the left. (1.8)

Offside Front Headlamp aim too low (1.8)

Offside Front Exhaust has a minor leak of exhaust gases (7.1.2)

Horn not working (1.6.2a)

Offside Rear Lower Exhaust has part of the system excessively deteriorated (7.1.1a)

Brake master cylinder fluid level below minimum level (3.6.G.1e)

Nearside Front Side repeater not working (1.4.A.2c)

Offside Front Windscreen washer provides insufficient washer liquid (8.2.3)