1992 Fiat Ducato

Nearside Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security SILL (6.2.2 (d) (i))

Offside Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security SILL (6.2.2 (d) (i))

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Integral body structure has excessive corrosion which adversely affects braking or steering wheel arch (6.1.1 (c) (ii)) DANGEROUS

Nearside Inner Vehicle structure has excessive corrosion which adversely affects braking or steering sill (6.1.1 (c) (ii)) DANGEROUS

Offside Inner Integral body structure has excessive corrosion which adversely affects braking or steering wheel arch (6.1.1 (c) (ii)) DANGEROUS

Offside Outer Vehicle structure has excessive corrosion which adversely affects braking or steering sill (6.1.1 (c) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Direction indicator not working (4.4.1 (a) (ii))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Position lamp not working (4.2.1 (a))

Nearside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Offside Front Direction indicator not working (4.4.1 (a) (ii))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust system not adequately supported (7.1.1)

Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside rear brake binding (3.7.B.1)

Offside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Registration plate lamp not working (1.1.C.1d)

vehicle structure corroded

Front Brake hose slightly deteriorated (3.6.B.4d)

brake pipes corroded front to rear

front both coil springs corroded

possible corrosion under the undertrays

slight corrosion under the front and rear wheel arches

underbody sprayed in wax oil

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Brake load sensing valve linkage stiff (3.6.E.3)

Brake load sensing valve stiff (3.6.E.3)

Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Headlamp deteriorated but light output not reduced (1.7.5a)

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Parking brake lever has little reserve travel (3.1.6b)

Rear Shock absorber has slight corrosion to the casing (2.7.2a)

battery insecure

Brake load sensing valve linkage seized (3.6.E.3)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Front Body has a sharp edge caused by corrosion (6.1.C.1)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Body has a sharp edge caused by corrosion (6.1.C.1)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Headlamp deteriorated but light output not reduced (1.7.5a)

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Parking brake lever has little reserve travel (3.1.6b)

Rear Shock absorber has slight corrosion to the casing (2.7.2a)

battery insecure

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Headlamp aim too high (1.8)

Nearside Headlamp insecure (1.7.3)

Offside Front wheel bearing rough when rotated (2.5.A.2)

Offside Headlamp aim too high (1.8)

Offside Headlamp insecure (1.7.3)

front wing/s rusty

Driver's seat insecure (6.2.A.1)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

front wing/s rusty

Nearside Inner Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Outer Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front brake disc slightly scored (3.5.1h)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front brake disc slightly scored (3.5.1h)