2000 Toyota Yaris

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Headlamp light intensity severely reduced (4.1.4 (a))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Brake pipe excessively corroded (1.1.11 (c))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Brake lever has abnormal movement of levers indicating excessive wear or maladjustment (1.1.15 (f))

Nearside Rear Suspension component mounting prescribed area is inadequately repaired (5.3.6 (a) (i))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill section (6.2.2 (d) (i))

Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Registration plate insecure (0.1 (a))

Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii))

Nearside Front Lower Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Lower Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)