1992 Rover 416

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

both rear tyres cracked

handbrake lever travel

Front constant velocity joint gaiter split (2.5.C.1a)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Stop lamp not working (1.2.1b)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Rear Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

both rear tyres cracked

handbrake lever travel

Nearside Registration plate lamp not working (1.1.5c)

Nearside Side repeater missing (1.4.A.2b)

Offside Registration plate lamp not working (1.1.5c)

Offside Stop lamp not working (1.2.1b)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Emissions not tested (7.0)

Nearside Outer Front constant velocity joint gaiter split (2.5.C.1a)

Offside Outer Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Nearside Rear Trailing arm synthetic bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Rear Radius arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

n/s/f c v boot has small pin hole.

Nearside Front Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front Front constant velocity joint is insecure (2.5.C.1b)

Nearside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)