1992 BMW 535

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Nearside Front Anti-roll bar attachment bracket/mounting damaged but its strength is not seriously reduced (5.3.3 (b) (i))

Offside Front Anti-roll bar attachment bracket/mounting damaged but its strength is not seriously reduced (5.3.3 (b) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Front Anti-roll bar attachment bracket/mounting damaged but its strength is not seriously reduced (5.3.3 (b) (i))

Offside Front Anti-roll bar attachment bracket/mounting damaged but its strength is not seriously reduced (5.3.3 (b) (i))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Prop shaft joint worn, but not excessively (6.1.7 (c) (i))

Prop shaft bearing has slight play (6.1.7 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Rear Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Coil spring not correctly located (2.4.C.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear coil spring broken (2.4.C.1a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Rear coil spring broken (2.4.C.1a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Rear Inner cv boot missing

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Inner cv boot missing

Parking brake lever has little reserve travel (3.1.6b)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

rear fuel lines corroded

Nearside Headlamp aim too low and too far to the left. (1.8)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Headlamp aim too low (1.8)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

rear fuel lines corroded

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Oil leak

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

nearside rear drive shaft oil seal leaking

offside rear drive shaft oil seal leaking

rear brake disc(s) corroded

Centre Exhaust system not adequately supported (7.1.1)

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Drag link end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.2.C.1c)

Nearside Front Drag link end ball joint has excessive play (2.2.B.1f)

Nearside Front Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Headlamp aim too low (1.8)

Nearside Rear Sub-frame has excessive play in a pin/bush (2.4.G.2)

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Rear Sub-frame has excessive play in a pin/bush (2.4.G.2)

Nearside Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Oil leak

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

nearside rear drive shaft oil seal leaking

offside rear drive shaft oil seal leaking

rear brake disc(s) corroded

Centre Exhaust system not adequately supported (7.1.1)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Front Headlamp aim too low (1.8)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Nearside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Sub-frame rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Sub-frame rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Oil leak

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)