1991 Peugeot 405

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside rear brake binding (3.7.B.1)

Offside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Steering rack gaiter split (2.2.D.2d)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

signs of front brakes binding at some point

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Outer Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Steering rack gaiter split (2.2.D.2d)

Rear Passenger's seat cannot be secured in the upright position. (6.2.A.2)

advise front brake disc;s

Nearside Headlamp aim too far to the right (1.8)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Exhaust has a major leak of exhaust gases (7.1.2)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Offside Side repeater not working (1.4.A.2c)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

condition of water hose in crank pulley area

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Offside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Rear Direction indicator adversely affected by the operation of another lamp (1.4.A.2h)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Direction indicator adversely affected by the operation of another lamp (1.4.A.2h)

Offside Rear fog lamp not working (1.3.2b)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Nearside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Offside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Offside Rear fog lamp not working (1.3.2b)

Brake servo vacuum pipe split (3.6.C.1b) DANGEROUS

advise/front pads/rear park brake cables/o/s trackrodend/n/s/f suspension top mount /n/s/f/tyre