1992 Renault Master

Brake fluid significantly below minimum mark (1.1.10 (d) (ii))

Brake performance not tested (1.2.1 (g))

Headlamp aim not tested (4.1.2 (b))

Nearside Front Steering linkage ball joint has excessive play steering rack (2.1.3 (b) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Front Steering linkage ball joint has excessive play steering rack (2.1.3 (b) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Rear Brake pipe leaking on a hydraulic braking system (1.1.11 (b) (ii)) DANGEROUS

Nearside Front Suspension component mounting prescribed area damaged but not considered excessive wheel arch (5.3.6 (a) (i))

Nearside Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Suspension component mounting prescribed area damaged but not considered excessive wheel arch (5.3.6 (a) (i))

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive Wheel arch (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area damaged but not considered excessive wheel arch (5.3.6 (a) (i))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Brake performance not tested ALL BRAKES BINDING (1.2.1 (g))

Headlamp aim not tested (4.1.2 (b))

Nearside Headlamp reflector seriously defective (4.1.1 (b) (ii))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced SPRING HANGER (6.1.1 (c) (i))

Nearside Side repeater not working (4.4.1 (a) (ii))

Offside Front All direction indicators not working (4.4.1 (a) (ii))

Offside Headlamp reflector seriously defective (4.1.1 (b) (ii))

Rear fog lamp not working (4.5.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Windscreen washer not working (3.5 (a))

general corrosion on vehicle

Nearside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Front Mechanical brake component has restricted free movement (3.5.1k)

Nearside Front Seat belt anchorage prescribed area is excessively corroded inner sill (5.2.6)

Nearside Front Seat belt anchorage prescribed area is excessively corroded inner wheel arch (5.2.6)

Nearside Front Seat belt anchorage prescribed area is excessively corroded outer sill (5.2.6)

Nearside Front Suspension spring mounting prescribed area is excessively corroded chassis leg (2.4.A.3)

Offside Front Lower Vehicle structure has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings chassis leg (6.1.B.2)

Offside Front Seat belt anchorage prescribed area is excessively corroded inner sill (5.2.6)

Offside Front Seat belt anchorage prescribed area is excessively corroded inner wheel arch (5.2.6)

Offside Front Seat belt anchorage prescribed area is excessively corroded outer sill (5.2.6)

Offside Front Suspension spring mounting prescribed area is excessively corroded chassis leg (2.4.A.3)

Offside Rear Stop lamp not working (1.2.1b)

Offside Rear Suspension spring mounting prescribed area is excessively corroded spring hanger (2.4.A.3)

Offside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Rear fog lamp not working (1.3.2b)

Battery insecure (1.9.1)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded shackle mount (2.4.A.3)

Nearside front brake binding (3.7.B.1)

Offside Rear Suspension spring mounting prescribed area is excessively corroded shackle mount (2.4.A.3)

Offside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Offside Stop lamp not working (1.2.1b)

Parking brake: efficiency below requirements (3.7.B.7)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front step underside corroded

Offside Front step underside corroded

Oil leak

corrosion n/s step/arch

Nearside Front front brake binding (3.7.B.1)

Brake load sensing valve linkage stiff (3.6.E.3)

Oil leak

corrosion n/s step/arch

one exhaust mounting rubber perished

Offside Rear Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Exhaust has a major leak of exhaust gases (7.1.2)

Headlamp switch faulty (1.7.1)

Nearside Front Tie bar/rod has excessive play in a ball joint (2.4.G.2)

Nearside Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Front Tie bar/rod has excessive play in a ball joint (2.4.G.2)

Offside Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Rear Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Nearside Front Tie bar/rod has slight play in a ball joint (2.4.G.2)

Offside Front Tie bar/rod has slight play in a ball joint (2.4.G.2)

Brake load sensing valve seized (3.6.E.3)

Rear fog lamp not working (1.3.2b)

Rear fog lamp tell tale not working (1.3.1b)

Nearside Front Tie bar/rod has slight play in a ball joint (2.4.G.2)

Offside Front Tie bar/rod has slight play in a ball joint (2.4.G.2)

Oil leak

Parking brake your vehicle has only just met the required brake efficiency. It would appear that your braking system requires adjustment or repair

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Exhaust has a major leak of exhaust gases (7.1.2)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear fog lamp not working (1.3.2b)

Registration plate lamp not working (1.1.C.1d)

Oil leak

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Horn Weak

Nearside Front Direction indicator not working (1.4.A.2c)

Rear fog lamp not working (1.3.2b)

Horn Weak

Oil leak

Offside Rear fog lamp not working (1.3.2b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Oil leak

Front registration plate missing (6.3.1a)

Offside Front Direction indicator not working (1.4.A.2c)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear registration plate deteriorated (6.3.1d)

Parking brake: efficiency below requirements (3.7.B.7)

Brakes imbalanced across an axle (3.7.B.5b)

Fuel system component insecure (7.2.1)

Nearside Front brake disc excessively scored (3.5.1h)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front brake disc excessively pitted (3.5.1h)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake hose ferrule excessively corroded (3.6.B.4e)

Rear Brake load sensing valve linkage seized (3.6.E.3)

Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Nearside Front Direction indicator not working (1.4.A.2c)

Nearside Rear Rear reflector missing (1.5.1a)

Offside Front front brake binding (3.7.B.1)

Offside Rear Rear reflector missing (1.5.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Front Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1) DANGEROUS