1991 Mazda MX-3

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Brake pipe excessively corroded running along subframe (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch-sill end (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill - floor pan (7.1.1 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Offside Front Position lamp not working (4.2.1 (a))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Coil spring mounting corroded and seriously weakened upper spring cup / mounting (5.3.1 (b) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch sill end (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength upper arch (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill-floor pan (7.1.1 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Power steering component leaking pump / rack (2.1.5 (a))

Registration plate lamp missing in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Suspension arm insecure and impairing directional stability lower suspension arm ball joint insecure locating pin / device ineffective / insecure (5.3.3 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Coolant leak ()

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Fuel Pipe/s corroded ()

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Power steering component has slight seepage from a component (2.1.5 (a))

Rear Brake disc worn, pitted or scored, but not seriously weakened x2 (1.1.14 (a) (ii))

exhaust system deteriorated

suspension bushes deteriorated / perished / cracked

suspension components corroded

various areas of corrosion

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Shock absorber has a serious fluid leak (2.7.3)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded floor to sill (2.4.A.3)

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Suspension component mounting prescribed area is excessively corroded floor (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded inner arch (2.4.A.3)

Offside Rear brake caliper leaking (3.6.A.1)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

N/S/R tyre perished

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Brake hose excessively deteriorated (3.6.B.4d)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

N/S/R tyre perished

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front Brake pad(s) wearing thin (3.5.1g)

front number plate damaged

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Registration plate lamp not working (1.1.C.1d)

Front Brake pad(s) wearing thin (3.5.1g)

front number plate damaged

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

N/S wiper split

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc slightly pitted (3.5.1h)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Upper Brake pipe slightly corroded (3.6.B.2c)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc slightly pitted (3.5.1h)

surface corrosion to rear cross member and suspension components

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc slightly pitted (3.5.1h)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Upper Brake pipe slightly corroded (3.6.B.2c)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc slightly pitted (3.5.1h)

surface corrosion to rear cross member and suspension components

Front registration plate letter/figure incomplete (6.3.1c)

Fuel cap/sealing device sealing washer missing (7.2.4c)

Nearside Headlamp aim too low (1.8)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too low (1.8)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Inner Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)