1992 Rover Mini

Front Exhaust has a major leak of exhaust gases Exhaust leaking from exh/manifold joint (6.1.2 (a))

Horn not working (7.7 (a))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting Floorpan has corrosion (6.2.2 (d) (i))

Oil leaking excessively from engine (8.4.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Front Play in steering rack inner joint(s)

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Play in steering rack inner joint(s)

Offside Rear Service brake excessively binding (1.2.1 (f))

Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Lower Suspension component ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Upper Suspension component ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Play in steering rack inner joint(s)

Offside Front Lower Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Upper Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Upper Suspension component ball joint excessively worn (5.3.4 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear fog lamp does not emit a steady red light (4.5.4 (a))

Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Play in steering rack inner joint(s)

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Front Position lamp not working (4.2.1 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

All position lamps not working (1.1.A.3b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Subframe mounting prescribed area is excessively corroded boot floor under fuel tank (2.4.A.3)

Nearside Rear Subframe mounting prescribed area is excessively corroded cross member with rear valance (2.4.A.3)

Registration plate lamp not working (1.1.C.1d)

Speedometer cannot be illuminated. (6.7.3)

Offside Rear valance starting to rust

both rear lower wheel arches / cross members starting to rust

Nearside Rear rust starting on inner wheelarch closing panel

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Rear rust starting on inner wheelarch closing panel

Oil leak

Rear Statutory seat belt missing (5.1.1)

Oil leak

Nearside Rear Radius arm has slight play in a pin/bush (2.4.G.2)

Brakes imbalanced across an axle (3.7.B.5b)

Horn not working (1.6.2a)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Rear Stop lamp not working (1.2.1b)

Nearside Rear Radius arm has slight play in a pin/bush (2.4.G.2)

Nearside Front Upper Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Inner Front Vehicle structure has slight corrosion (6.1.B.2)

Oil leak

Nearside Front Upper Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Fuel system component insecure (7.2.1)

Offside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Inner Front Vehicle structure has slight corrosion (6.1.B.2)

Oil leak

Stop lamp not working (1.2.1b)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Offside Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Headlamp aim too low (1.8)

Offside Headlamp insecure (1.7.3)

Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Rear Vehicle structure has slight corrosion (6.1.B.2)

Offside Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Nearside Front Headlamp aim too low (1.8)

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front Steering rack gaiter split (2.2.D.2d)

Nearside Rear Sub-frame corroded and seriously weakened (2.4.G.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Rear Vehicle structure has slight corrosion (6.1.B.2)

Offside Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

o/s outer sill o/s inner sill o/s wheel arch n/s wheel arch corroded through