1992 Honda CB750

corrosion to frame and rear swing arm

security of headligh

Front Brake disc worn, pitted or scored, but not seriously weakened Corroded (1.1.14 (a) (ii))

Motorcycle structure is corroded but structural rigidity is not significantly reduced Swingarm (6.1.1 (c) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened Corroded (1.1.14 (a) (ii))

Nearside Front Shock absorber has a serious fluid leak (5.3.2 (b))

Drive chain slightly loose (6.2.1d)

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Rear Tyre has a tear caused by separation or partial failure of its structure (4.1.2a(ii))

Roller brake test The less effective brake control does not achieve an efficiency of 25%. (3.3.A2b)

Drive chain slightly loose (6.2.1d)

corrosion to frame

corrosion to rear swing arm

front and rear brake discs pitted

wear rear sprocket

Drive chain worn but not considered excessive (6.2.1e)

Rear Brake disc(s) slightly pitted (3.2.A1l)

Rear Drive chain sprocket slightly worn (6.2.1e)

Rear suspension component slightly corroded. (2.4.A.1a)

Front Brake lever cannot be applied smoothly (3.1.3d)

Rear Tyre has a tear caused by separation or partial failure of its structure (4.1.2a(ii))

Drive chain worn but not considered excessive (6.2.1e)

Rear Brake disc(s) slightly pitted (3.2.A1l)

Rear Drive chain sprocket slightly worn (6.2.1e)

Rear suspension component slightly corroded. (2.4.A.1a)

condition of brake discs

corrosion to frame at rear

corrosion to rear swinging arm

rear disc badly corroded/but performance on test ok/ advise new rear disc

Front Floor brake test indicates a binding brake (3.3.C2c) DANGEROUS

rear disc badly corroded/but performance on test ok/ advise new rear disc

rear brake disc badly corroded surface/but not pitted

rear luggage top box insecurely mounted

Front Roller brake test indicates a binding brake (3.3.A1a)

Steering movement excessively 'notchy' with the wheel raised (2.2.1b)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Nearside Rear shock absorber seal failed and leaking oil (2.4.A.1c)

Offside Rear shock absorber seal failed and leaking oil (2.4.A.1c)

wear to rear sprocket

Offside Front Brake disc(s) is excessively distorted (3.2.A1m)

Front Roller brake test indicates a binding brake (3.3.A1a)

Front Roller brake test indicates excessive fluctuation of brake effort (3.3.A1d)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

choke stuck on

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))