1991 BMW 3 Series

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Headlamp aim too low (1.8)

Nearside Registration plate lamp not working (1.1.C.1d)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Front Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Windscreen wiper blade insecure (8.2.2)

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Headlamp not working on dipped beam (1.7.5a)

Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Registration plate lamp not working (1.1.5c)

Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Front Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Exhaust has a major leak of exhaust gases (7.1.2)

Offside Front Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

both rear trailing arm bush's have sign's of perishing, and very slight movement. Would suggest changing them soon. More so the offside rear.

nearside rear inner side light inopp

sign's of corrosion all under vehicle, and on the fuel and brake pipe's, all ok at present moment

slight play in both front wheel's, seem's to be in the sterring arm's

there are two small hole's in both front inner wing's under bonnet. Not near low bearing point

Fuel hose leaking (7.2.3)

Offside Outer Front Front suspension has excessive movement at a suspension ball joint (2.5.A.1c)

both diff out put seals leaking very badly