1997 MG Mgf

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Vehicle structure is corroded but structural rigidity is not significantly reduced Covered In Underseal (6.1.1 (c) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill and inner arch/sill end (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill and inner arch/sill end (5.3.6 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Rear fog lamp switch not operating in accordance with the requirements tell tale not working (4.5.3 (a))

Nearside Front caliper carrier bolts suspect top one not fully seated ?? and washers on bottom bolt

Nearside Outer Seat belt anchorage prescribed area is corroded but not considered excessive sill (7.1.1 (a) (i))

Offside Rear Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

hi level stop light not working

underside heavily covered

Central Stop lamp(s) light intensity obviously reduced (4.3.3 (a) (i))

Complete underbody covered in protective wax

Front Anti-roll bar pin or bush worn but not resulting in excessive movement Nearside & Offside perished (5.3.4 (a) (i))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Offside Front Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Offside Front Upper Suspension component ball joint excessively worn (5.3.4 (a) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Tyre not fitted in accordance with side wall instructions (5.2.3 (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Offside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Stop lamp(s) remains on when the brakes are released (4.3.2 (a) (iii)) DANGEROUS

Central Stop lamp(s) light intensity obviously reduced (4.3.3 (a) (i))

sills and floor in poor condtion

corrosion underside vehicle-sills, floor, arches, some brake pipes.

front tyres have small splits/cuts but not exposing chords.

parking brake slightly out of balance

corrosion in all under-side components. subframes, outer sills. brakes, inner sills

corrosion in rear wheel arches

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Headlamp has a product on the light source so that the light output is severely reduced (1.7.5a)

Offside Headlamp has a product on the light source so that the light output is severely reduced (1.7.5a)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

battery not bolted down

corrosion in all under-side components. subframes, outer sills. brakes, inner sills

corrosion in rear wheel arches

rear plastic window very close to exhaust manifold

both headlamp patterns weak

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Horn not working (1.6.2a)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

both headlamp patterns weak

Headlamp not in a clean condition but not affecting beam image (1.2.4a)

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Headlamp not in a clean condition but not affecting beam image (1.2.4a)

Horn not working (1.6.2a)

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Headlamp not working on dipped beam (1.7.5a)

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Headlamp not in good working order but not adversely affecting beam image (1.2.4a)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Headlamp not in good working order but not adversely affecting beam image (1.2.4a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

corrosion appearing both inner sills

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Lower Suspension arm corroded and seriously weakened (2.4.G.1)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Offside Front Lower Suspension arm corroded and seriously weakened (2.4.G.1)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Headlamp not in good working order but not adversely affecting beam image (1.2.4a)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Headlamp not in good working order but not adversely affecting beam image (1.2.4a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

corrosion appearing both inner sills

Front brake disc slightly pitted (3.5.1h)

Nearside Track rod end ball joint has slight play (2.2.B.1f)

play in o/s/r upper ball joint

play in rear trailing arm bushes

beam patterns are weak

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Rear Lower Shock absorber has an excessively worn bush (2.7.4)

Nearside Rear Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Rear brake disc excessively pitted (3.5.1h)

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Rear Lower Shock absorber has an excessively worn bush (2.7.4)

Offside Rear brake disc excessively pitted (3.5.1h)

Centre N/S sill area starting to corrode.Front discs worn.Both head lights slightly low intensity.

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Horn not a continuous or uniform sound (1.6.2e)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Stop lamp not working (1.2.1b)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

front brake discs inner faces worn