1996 Mazda MX-5

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner wing / engine bay (6.1.1 (c) (i))

Nearside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill/flitch (6.1.1 (c) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner wing x2 (6.1.1 (c) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced chassis x member behind bumper (6.1.1 (c) (i))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill behind wing (6.1.1 (c) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced floor (7.1.1 (a) (i))

Offside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill/flitch (6.1.1 (c) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner wing (6.1.1 (c) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Play in steering rack inner joint(s) ()

Nearside Front Position lamp incorrect colour (4.2.3 (a) (i))

Nearside Front Wheel/tyre protruding beyond wheel arch ()

Nearside Rear Wheel/tyre protruding beyond wheel arch ()

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Position lamp incorrect colour (4.2.3 (a) (i))

Offside Front Wheel/tyre protruding beyond wheel arch ()

Offside Front wing insecure at bottom

Offside Rear Wheel/tyre protruding beyond wheel arch ()

Oil leak, but not excessive (8.4.1 (a) (i))

general corrosion to front suspension components

general corrosion to rear suspension components

Offside Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

n/s/r inner arch repaired with body filler, o/s/r minner arch corroded and holed

underside and suspension components have advanced corrosion

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Nearside Front Headlamp aim too high (4.1.2 (a))

Nearside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

n/s/r inner wheel arch been repaired with body filler , o/s/r inner arch corroded andn holed

underside and suspension components have advanced corrosion

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement both lower arm bushs (2.4.G.2)

front and rear susp slight corrosion

Nearside Rear Stop lamp not working (1.2.1b)

Offside Front Suspension component mounting prescribed area is excessively corroded floor pan (2.4.A.3)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Subframe mounting prescribed area is excessively corroded boot floor (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement both lower arm bushs (2.4.G.2)

front and rear susp slight corrosion

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Vehicle structure has excessive corrosion which adversely affects braking or steering (6.1.A.1)

Offside Vehicle structure has excessive corrosion which adversely affects braking or steering (6.1.A.1)

Offside Rear rear parking brake recording little or no effort (3.7.B.6a) DANGEROUS

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

handbrake travel

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Horn not working (1.6.2a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Brakes imbalanced across an axle (3.7.B.5b) DANGEROUS

Rear rear parking brake recording little or no effort (3.7.B.6a) DANGEROUS

Brake pipe slightly corroded (3.6.B.2c)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Centre Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Brake pipe slightly corroded (3.6.B.2c)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Centre Rear Brake pipe slightly corroded (3.6.B.2c)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Service brake: efficiency below requirements (3.7.B.7)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Nearside front brake juddering slightly (3.7.A.2b)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Offside front brake juddering slightly (3.7.A.2b)

battery seat area rusty

cat missing

centre chassis rails damaged

front top and bottom ball joint rubber boots perished

nearside boot floor and nearside rear inner wheel arch excessivly corroded

nearside front wing rusted and holed

nearside outer sill rusty

nearside rear light lens is cracked

offside front of sill rusty

offside park brake reading low

slight front brake inbalance

strut brace fitted mounting studs are short

surface corrosion to vehicle in many places

suspension low

Nearside Headlamp aim too low (1.8)

Nearside Side repeater not working (1.4.A.2c)

Nearside Track rod end loose (2.2.B.1d)

Offside Headlamp aim too low (1.8)

Offside Steering rack gaiter insecure (2.2.D.2d)

Offside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

front brake application uneven (3.7.B.2)

Brake pipe slightly corroded (3.6.B.2c)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Nearside front brake juddering slightly (3.7.A.2b)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Offside front brake juddering slightly (3.7.A.2b)

battery seat area rusty

cat missing

centre chassis rails damaged

front top and bottom ball joint rubber boots perished

nearside boot floor and nearside rear inner wheel arch excessivly corroded

nearside front wing rusted and holed

nearside outer sill rusty

nearside rear light lens is cracked

offside front of sill rusty

offside park brake reading low

strut brace fitted mounting studs are short

surface corrosion to vehicle in many places

suspension low

Offside Outer Track rod end ball joint has excessive play (2.2.B.1f)

Offside Rear Shock absorber has a serious fluid leak (2.7.3)

Offside rear parking brake recording little or no effort (3.7.B.6a)

front brake application uneven (3.7.B.2)

Nearside Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Shock absorber has a light misting of oil (2.7.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

front discs ballance

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

front discs ballance

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake is not capable of being maintained in operation by direct mechanical action only (3.1.2)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Steering rack gaiter split (2.2.D.2d)

Windscreen washer provides insufficient washer liquid (8.2.3)

rear parking brake recording little or no effort (3.7.B.6a)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Exhaust noisy (7.1.4)

coil spring corroded (2.4.C.1b)

no cat fitted on exhaust

Rear Sub-frame synthetic bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear brake disc slightly pitted (3.5.1h)

Rear rear brake juddering slightly (3.7.A.5b)

emissions checked on non cat car

Front Tyre worn close to the legal limit (4.1.E.1)

nearside chassis rail is damaged

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Tyre worn close to the legal limit (4.1.E.1)

nearside chassis rail is damaged

Offside Front Windscreen wiper blade deteriorated (8.2.2)