1991 Mazda MX-5

Central Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Central Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

general under body corrosion

Central Front Registration plate inscription illegible (0.1 (b))

Central Rear Registration plate inscription illegible (0.1 (b))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Exhaust system insecure (6.1.2 (a))

Offside Front Side repeater missing (4.4.1 (a) (ii))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Inner Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Inner Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Offside Rear Body has slight corrosion (6.1.B.2)

Offside Rear Body has slight corrosion (6.1.B.2)

Oil leak

Play in steering rack inner joint(s)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Under-trays fitted obscuring some underside components

all metal brake pipes greased at time of test

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Body has slight corrosion (6.1.B.2)

Offside Rear Body has slight corrosion (6.1.B.2)

Oil leak

Play in steering rack inner joint(s)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Under-trays fitted obscuring some underside components

all metal brake pipes greased at time of test

Oil leak

Nearside Front coil spring broken (2.4.C.1a)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear coil spring broken (2.4.C.1a)

Offside Rear coil spring broken (2.4.C.1a)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Oil leak

Nearside Rear Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Vehicle structure has slight corrosion (6.1.B.2)

Offside Front Vehicle structure has slight corrosion (6.1.B.2)

Rear Brake pipe slightly corroded (3.6.B.2c)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Offside Front Brake pipe leaking (3.6.A.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

center exhaust box blowing

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

center exhaust box blowing

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Outer Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Exhaust has a minor leak of exhaust gases (7.1.2)

middle to raer exhaust clamp insecure and correded

offside rear brake slight binding