2002 Jaguar X-type

Headlamp levelling device inoperative (4.1.5 (a))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Power steering malfunctioning tight spots (2.1.5 (a))

Fuel Pipe/s corroded ()

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pad(s) wearing thin both (1.1.13 (a) (ii))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

coolant reservoir empty

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Fuel Pipe/s corroded ()

Nearside Rear Nail in tyre ()

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust emissions likely to be affected by an induction leak (8.2.1.1 (b))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Brake pipe excessively corroded front to rear (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Integral body structure is deformed and structural rigidity is significantly reduced sill (6.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Parking brake lever defective but can be satisfactorily operated very little reserve travel (1.1.6 (d))

Rear both rear tyres showing siqns of age ie cracking on sidewalls

Offside Front Brake pipe excessively corroded to/rear/2/pipes (3.6.B.2c)

Offside Front Front position lamp(s) not working head (1.1.A.3b)

Offside Front Front position lamp(s) not working side (1.1.A.3b)

Offside Front Inner Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Shock absorber has a serious fluid leak (2.7.3)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen wiper does not clear the windscreen effectively torn/blades (8.2.2)

Parking brake lever has little reserve travel (3.1.6b)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Rear Fluid suspension unit slightly deteriorated (2.4.D.1b)

Parking brake lever has little reserve travel (3.1.6b)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

wear in near side front tyre only just legal