2006 Mazda 2

Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Suspension component pin or bush excessively worn axle (5.3.4 (a) (i))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Suspension component pin or bush excessively worn axle (5.3.4 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

rear exhaust very rusty

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

rear exhaust very rusty

Centre Stoplight not working

Nearside Front Outer wheel rim distorted

Nearside Front Upper gaiter on anti roll bar splitting

Nearside Rear Tyre worn close to the legal limit Near limit & very badly worn on edges (4.1.E.1)

Offside Rear Brake binding slightly

Offside Rear Tyre worn close to the legal limit Near limit & very badly worn on edges (4.1.E.1)

Exhaust emits an excessive level of metered smoke for a turbo charged engine (7.4.B.3b)

Offside Headlamp not working on dipped beam (1.7.5a)

Speedometer cannot be illuminated. (6.7.3)

Centre Stoplight not working

Nearside Front Outer wheel rim distorted

Nearside Front Upper gaiter on anti roll bar splitting

Nearside Rear Tyre worn close to the legal limit Near limit & very badly worn on edges (4.1.E.1)

Offside Rear Brake binding slightly

Offside Rear Tyre worn close to the legal limit Near limit & very badly worn on edges (4.1.E.1)

Speedometer cannot be illuminated. (6.7.3)

Travel on handbrake

Offside Rear reflector missing (1.5.1a)

Travel on handbrake

front pads low - n/s/f tyre cuts in sidewall.