2006 Ssangyong Rodius

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Service brake lagging in operation (1.2.1 (d))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced sill. (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively damaged significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Seat belt anchorage prescribed area is corroded but not considered excessive sill. (7.1.1 (a) (i))

Nearside Windscreen wiper blade defective (3.4 (b) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

hand brake just meets required efficiency 16% recorded.

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Nail in tyre ()

Offside Rear Parking (secondary brake) grabbing slightly (1.3.1 (c))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Central Upper Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Nail in tyre ()

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

hand brake may need some adjustment or repair.imbalance..

Nearside Front Lower Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Nearside Rear Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength subframe/spring mounting area (5.3.6 (a) (i))

Offside Rear Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength subframe/spring mounting area (5.3.6 (a) (i))

both front tyres heavily worn

both outer sills very soft and corroded

front and rear subframes have heavy surface corrosion(unable to fully inspect)

heavy surface corrosion to front and rear suspension components(unable to fully inspect)

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Headlamp aim too high (4.1.2 (a))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Brake hose twisted (found during steering lock to lock check) (2.2.D.2b)

Nearside Front Lower Suspension arm corroded and seriously weakened (2.4.G.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Registration plate lamp insecure (1.1.C.1c)

Nearside Rear Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Offside Rear Coil spring mounting corroded but not seriously weakened (2.4.C.3c)

corrosion to underside of vehicle.covers prevent full inspection of some components

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Child seat fitted not allowing full inspection of adult belt

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Play in steering rack inner joint(s)

hi level brake lamp not working

Offside Front Shock absorber has a serious fluid leak (2.7.3)

Offside Registration plate lamp not working (1.1.C.1d)