1981 Land Rover 88

Oil leak, but not excessive engine/gearbox areas (8.4.1 (a) (i))

Steering system slightly rough (2.1.1 (a))

Nearside Front Headlamp aim too low (4.1.2 (a))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Rear Upper Shock absorbers has an excessively worn bush (5.3.2 (c))

Steering system excessively rough (2.1.1 (a))

Brakes imbalanced across an axle by more than 50% (1.2.1 (b) (ii)) DANGEROUS

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front and osf sphere seals displaying weepage x 2

Oil leak, but not excessive engine/transmission areas (8.4.1 (a) (i))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.2.2 (a) (i))

Front steering wheel sphere seals weeping x 2

Oil leak, but not excessive engine/gearbox area (8.4.1 (a) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

hazard switch faulty

Fuel cap/sealing device ineffective (6.1.3 (b) (i))

Nearside Front Headlamp aim too low (4.1.2 (a))

Offside Front Headlamp aim too low (4.1.2 (a))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front steering wheel sphere seals weeping x 2

Oil leak, but not excessive engine/gearbox area (8.4.1 (a) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

hazard switch faulty

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front steering spheres seals slight weeping/wear

Offside Front floor pan and body supports corroded

Oil leak, but not excessive engine area (8.4.1 (a) (i))

slight oil leak from engine

slight oil leak from nearside front tractor joint

surface corrosion to exhaust system

Centre Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Exhaust emissions hydrocarbon content excessive (7.3.B.1b)

Hazard warning lamps not flashing in phase, with ignition off (1.4.B.1f)

Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Hazard warning tell tale not working correctly (1.4.B.1e)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Centre Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Direction indicator incorrect colour (1.4.A.2f)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Direction indicator incorrect colour (1.4.A.2f)

Offside Front Direction indicator incorrect colour (1.4.A.2f)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Hazard warning switch faulty (1.4.B.1d)

Horn not working (1.6.2a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too high (1.8)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Centre Lower Parking brake mechanism/associated mounting prescribed area is excessively corroded (3.1.9)

Nearside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Axle king pin has excessive play in pin and/or bush adversely affecting the steering (2.5.A.3a)

Offside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

chassis in very corrosive conditions through out

Centre Exhaust has part of the system slightly deteriorated (7.1.1a)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

general previous welding repairs throughout chassis

general surface corrosion of chassis

rear axle check straps broken