2006 Chrysler-jeep 300

Electronic stability control warning lamp indicates a fault (7.12 (e))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill outer sills are covered (5.3.6 (a) (i))

Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Suspension arm ball joint dust cover severely deteriorated both (5.3.4 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Play in steering rack inner joint(s) ()

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Upper Suspension arm has excessive play in a pin/bush long straight arm (2.4.G.2)

Nearside rear parking brake recording little or no effort little effort (3.7.B.6a)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Upper Suspension arm has excessive play in a pin/bush long straight arm (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front Brake pad(s) wearing thin (3.5.1g)

both sides front wiper blade rubbers split at ends

Offside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Front Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Parking brake: efficiency below requirements (3.7.B.7)

rear brake application uneven (3.7.B.2)

rear brakes release unevenly (3.7.B.4)

Front Brake pad(s) wearing thin (3.5.1g)

both sides front wiper blade rubbers split at ends

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Upper Suspension arm ball joint dust cover missing (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Front Brake pad(s) wearing thin (3.5.1g)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.C.1b)

offside/nearside rear brakes slightly binding

Parking brake: efficiency below requirements (3.7.B.7)

rear parking brake recording little or no effort (3.7.B.6a)